Factory Reset - Turbo CREO SL Manual De Usuario

ERROR
1. BATTERY ERROR
2. BATTERY NOT FOUND
3. MOTOR ERROR
4. MOTOR NOT FOUND
5. BATTERY & MOTOR ERROR
6. TCU COIN CELL BATTERY LOW
7.
RANGE EXTENDER ERROR
Before a new or used bicycle is sold, the new user should perform a factory reset of the TCU display, to reset the
peak power and support mode settings.
7.6
+
4
10
SEC
To perform a factory reset (Fig. 7.6).
Long-press (hold) the Mode button. (1)
„
Press and release the Power button (2) (continue pressing the Mode button 1). LEDs will light up (3).
„
Continue to long-press the Mode button for 10 seconds (4), until the LEDs turn off (5) and turn back on (6).
„
Release the Mode button (7).
„
Factory reset is complete.
„
15
SOLUTION
For Error Codes 1-4 try the following solutions.
• Reboot your bicycle.
• Check Mission Control App for more information.
• If the problem persists contact your Authorized Specialized Retailer.
Contact your Authorized Specialized Retailer.
Replace the coin cell battery in the TCU.
• Check the RE plug is inserted correctly into the charge port and locked.
• Disconnect the RE and check for water in the plug.
• If the problem persists contact your Authorized Specialized Retailer.

7.7. FACTORY RESET

1
3
1
2
5
7
6