Safety Notes; Setting The Spotlight Into Operation - IMG STAGELINE ODC-100/WS Manual De Instrucciones

DMX LED Spotlight
Operation of the spotlight is easy for users with
basic knowledge in DMX control . However, please
read the instructions carefully prior to operation
and keep them for later reference . On page 2,
you will find the spotlights ODC-100 / WS and
PARC-100 / WS together with the menu structure .
1 Applications
This LED spotlight is used for illumination, e . g . on
stage, in discotheques and function rooms . The
light source is a powerful white COB LED (COB =
chip-on-board technology): Many individual LED
chips are densely packed on a PCB to provide a
uniform light distribution .
The spotlight is designed for control via a
DMX light controller (3 DMX control channels),
but it can also be operated independently without
a controller . The ODC-100 / WS is weatherproof
(IP 66) and therefore also suited for outdoor
applications .

2 Safety Notes

The spotlight corresponds to all relevant directives
of the EU and is therefore marked with
WARNING The spotlight uses dangerous
mains voltage . Leave servicing to
skilled personnel; inexpert han-
dling may result in electric shock .
•
The spotlight PARC-100 / WS is suitable for
indoor use only . Protect it against dripping
water and splash water, high air humidity and
heat (admissible ambient temperature range:
0 – 40 °C) .
The spotlight ODC-100 / WS is suitable for out-
door applications (admissible ambient temper-
ature range: −20 to +40 °C) .
•
Immediately disconnect the mains plug from
the socket
1 . if the spotlight or the mains cable is visibly
damaged,
2 . if a defect might have occurred after the
spotlight was dropped or suffered a similar
accident,
3 . if malfunctions occur .
In any case the spotlight must be repaired by
skilled personnel .
8
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug .
•
For ODC-100 / WS only: A damaged mains cable
must be replaced by skilled personnel only .
•
No guarantee claims for the spotlight and no
liability for any resulting personal damage or
material damage will be accepted if the spot-
light is used for other purposes than originally
intended, if it is not safely installed or not
correctly connected or operated, or if it is not
repaired in an expert way .
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harmful
to the environment .
3 Setting the Spotlight
into Operation
3.1 Installation
•
Always position the spotlight in such a way
to ensure sufficient air circulation during
operation . Never cover the cooling fins of the
.
housing .
•
Always keep a minimum distance of 50 cm to
the illuminated object .
WARNING When the spotlight is installed at
safety rope through the eyebolt on the rear of
the spotlight and fasten it in such a way that the
maximum falling distance of the spotlight will
not exceed 20 cm .
1 . Install the spotlight via its mounting brackets,
e . g . with a stable mounting screw or a support
for lighting units (C hook) on a cross bar .
To align the spotlight, release the two lock-
ing screws of the mounting brackets . Adjust
the desired inclination of the spotlight and
fasten the screws .
2 . Alternatively, set up the spotlight on its own:
Fold out the mounting brackets underneath
the spotlight and use them as a stand . Then
fasten the locking screws .
a place where people may walk or
sit under it, additionally secure it,
e . g . via a safety rope . Guide the