Tabla de contenido
DMX LED Spotlight
These instructions are intended for installers of the
unit and for users with basic knowledge in DMX
control . Please read the instructions carefully prior
to operation and keep them for later reference .
All operating elements and connections
described can be found on the fold-out page 3 .
Contents
1
Operating Elements and Connections . . . . . 10
2
Safety Notes . . . . . . . . . . . . . . . . 10
3
Applications . . . . . . . . . . . . . . . . 11
4
Mounting . . . . . . . . . . . . . . . . . 11
5
Setting into Operation . . . . . . . . . . . 11
6
Operation . . . . . . . . . . . . . . . . . 11
6.1 Operation without DMX controller . . . . . . . 11
6.1.1 Colour spotlight and stroboscope . . . . . . 11
6.1.2 Programs running automatically . . . . . . . 12
6.1.3 Music control . . . . . . . . . . . . . . . 12
(master-slave mode) . . . . . . . . . . . . . 12
6.3 Operation with a DMX controller . . . . . . . 12
6.3.1 DMX connection . . . . . . . . . . . . . . 12
6.3.3 Adjusting the DMX start address . . . . . . . 13
6.3.4 DMX channels and functions . . . . . . . . 13
6.3.5 Using sub-addresses . . . . . . . . . . . . 14
6.4 Automatic display switch-off . . . . . . . . . 14
6.5 White correction . . . . . . . . . . . . . . 15
6.6 Key lock . . . . . . . . . . . . . . . . . . 15
6.7 Indication of firmware version . . . . . . . . 15
7
Specifications . . . . . . . . . . . . . . . 15
1 Operating Elements and
Connections
1 Mounting /set-up brackets
2 Display
3 Locking screws for the mounting /set-up brackets
4 Microphone for music control
5 XLR chassis mount plug DMX IN: DMX signal
input for connection of a light controller or to the
DMX signal output of another spotlight
6 XLR jack DMX OUT: DMX signal output for con-
nection to the DMX input of another DMX-con-
trolled unit
7 Buttons to select the operating mode and to
change adjustments
8 Mains cable for connection to a socket
(230 V~ / 50 Hz)
10
2 Safety Notes
The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit uses hazardous mains
voltage . Leave servicing to skilled
personnel only and do not insert
anything into the air vents; inex-
pert handling may result in electric
shock .
•
The unit is suitable for indoor use only . Protect
it against dripping water and splash water, high
air humidity, and heat (admissible ambient tem-
perature range 0 - 40 °C) .
•
Do not operate the unit or immediately discon-
nect the mains plug from the mains socket
1 . if the unit or the mains cable is visibly dam-
aged,
2 . if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3 . if malfunctions occur .
In any case the unit must be repaired by skilled
personnel .
•
A damaged mains cable must only be replaced
by skilled personnel .
•
Never pull the mains cable for disconnecting
the mains plug from the socket, always seize
the plug .
•
For cleaning only use a dry, soft cloth, never use
chemicals or water .
•
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is
not safely mounted, not correctly connected or
operated, or if it is not repaired in an expert way .
•
Important for U. K. Customers!
The wires in this mains lead are coloured in ac-
cordance with the following code:
green / yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1 . The wire which is coloured green and yellow
must be connected to the terminal in the plug
which is marked with the letter E or by the
earth symbol
, or coloured green or green
and yellow .
2 . The wire which is coloured blue must be
.
Capítulos
Tabla de contenido
