Independent Operation; Operation With A Dmx Controller - IMG STAGELINE ODC-100/WS Manual De Instrucciones

4 Operation
The operating modes and the setting functions
are selected via a menu by means of the buttons
MENU, ENTER, UP and DOWN . Figure 3 on page
2 shows the selection of the modes and functions
via the menu and the indications on the display .

4.1 Independent operation

For independent operation, it is possible to set the
brightness, to activate the stroboscope function
and to set the flash rate on the spotlight .
1) Press the button MENU repeatedly until the
display shows
2) Press the button ENTER once or twice so that
the display shows the brightness adjusted
( ...
3) To set the desired brightness, press the buttons
UP and DOWN .
4) To activate the stroboscope function, press the
button ENTER once again so that the display
shows
5) To set the flash rate (
the buttons UP and DOWN .
6) To change the brightness of the flash, press
the button ENTER to return to the menu item
for the brightness, then press the button UP
or DOWN to change the value .
7) To deactivate the stroboscope function, set the
flash rate to
Note: Do not use the button MENU to exit the menu
item for the brightness or the flash rate before switching
off the spotlight . If you do, the spotlight will remain dark
when it is switched on again .

4.2 Operation with a DMX controller

For operation via a DMX light controller (e . g .
DMX-1440 or DMX-510USB from IMG STAGE-
LINE), the spotlight is equipped with three DMX
control channels . DMX stands for Digital Multi-
plex and means digital control of multiple DMX
units via a common control cable . The functions
of the channels and the DMX values can be found
in chapter 4 .2 .3 (fig . 6) .
10
.
) .
.
...
.
4.2.1 Connection
For DMX signal transmission, special cables should
be used (e . g . CDMXN-... from IMG STAGELINE) .
For cable lengths exceeding 150 m or for control
of more than 32 units via a single DMX output, it
is generally recommended to insert a DMX level
matching amplifier (e . g . SR-103DMX) .
1) Connect the input DMX IN to the DMX output
of the light controller or to the DMX output of
another DMX-controlled unit .
For the spotlight ODC-100 / WS, connect
the plug (C) of the cable DMX IN to the inline
jack (D) of the supplied cable equipped with
an XLR plug . Then fasten the nut to secure
this connection .
DMX IN
Fig. 5 DMX connection ODC-100 /WS
Use an extension cable to connect the XLR plug
to the DMX output of the light controller or, if
additional DMX-controlled units are used, to
the DMX output of the last DMX-controlled
), press unit .
2) Connect the output DMX OUT to the DMX
input of the second DMX unit . Connect the
output of the second DMX unit to the input of
the third DMX unit etc . until all DMX-controlled
units have been connected in a chain .
If the DMX connection cables between
the units are too short when interconnecting
multiple ODC-100 / WS spotlights, use suitable
extension cables, e . g .
ODP-34DMX
ODP-34DMX / 10 length: 10 m
3) To prevent interference in signal transmission,
in case of long cables or a multitude of units
connected in series, terminate the DMX output
of the last DMX unit in the chain with a 120 Ω
resistor (> 0 .3 W): Connect a corresponding
terminating plug (e . g . DLT-123) to the DMX
output jack .
The easiest way to terminate the DMX
output of the ODC-100 / WS is to separate an
extension cable ODP-34DMX and to connect
D
C
length: 2 m or