Setting The Start Address; Dmx Channels And Functions; Cleaning The Spotlight - IMG STAGELINE ODC-100/WS Manual De Instrucciones

the resistor to the pins 2 and 3 of the plug .
Connect the plug with the resistor to the inline
jack of the cable DMX OUT . If no terminating
resistor is required, screw the protective cover
provided onto the inline jack of the cable .

4.2.2 Setting the start address

For separate control of all DMX units connected
to the light controller, each unit must have its own
start address . Example: If the first DMX channel of
the spotlight is to be controlled by the light con-
troller via DMX address 17, set the start address
on the spotlight to 17 . All other DMX channels
of the spotlight will be automatically assigned to
the following addresses (i . e . the addresses 18 and
19 for the start address 17) .
1) Press the button MENU repeatedly until the
display shows
2) Press the button ENTER . The display will show
the start address adjusted (
3) To set the desired address, press the buttons
UP and DOWN . Now the spotlight can be
operated via the light controller .
Note: When the display shows the menu item
and DMX signals are present at the DMX input,
the dot at the right end of the display will flash .

4.2.3 DMX channels and functions

DMX DMX
channel value
1 000 – 255
000
2
001 – 250
251 – 255
000 – 010
3
011 – 255
Fig. 6 DMX overview
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
.
...
Function
brightness 0 %  100 %
response of LEDs
slow response
response very slow  fast
immediate response
stroboscope off
stroboscope slow  fast
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®

5 Cleaning the Spotlight

Clean the pane in front of the LED at regular inter-
vals depending on impurities . This is the only way
to ensure that light will be emitted at maximum
brightness . Before cleaning, disconnect the
mains plug from the socket. Only use a soft
clean cloth and a glass cleaner .
For cleaning the other parts of the housing
of the PARC-100 / WS, only use a soft clean cloth .
Never use any fluid; it may leak into the spotlight
and damage it .
The weatherproof housing of the ODC-
100 / WS may also be cleaned with a damp cloth
and a mild detergent .
6 Specifications
Data protocol: . . . . . . . . . . . DMX 512
Number of DMX channels: . 3
) .
Light source: . . . . . . . . . . . . white COB LED
Power consumption: . . . . . 100 W
Beam angle: . . . . . . . . . . . 60°
Colour temperature: . . . . . 5600 K
or
DMX connections: . . . . . . . XLR, 3 poles
Pin assignment: . . . . . . . . Pin 1 = ground
Power supply: . . . . . . . . . . . 230 V/ 50 Hz
Power consumption: . . . . . . 120 VA max .
Protection of housing: . . . . . IP 66 (ODC- only)
Dimensions w/o
mounting bracket: . . . . . . . ⌀ 185 × 250 mm
Weight: . . . . . . . . . . . . . . . 6 .5 kg
Subject to technical modification .
Pin 2 = DMX−
Pin 3 = DMX+
11