This sturdy machine operates by keeping the wheel horizontal for both bead breaking
and for demounting/mounting.
Operations are performed by the operator by means of pedal controls on a pedal unit
and by means of manual controls on the control panel.
Thanks to this machine, any bead-breaking, demounting and mounting operations
can be performed on the above tyre types.
The wheel is kept horizontal at all times and always perfectly centred on the self-
centring device.
Wheel loading and unloading operations are made easier by an ergonomic lift (optional
kit) which makes the operator's job easier.
A strong point is the elimination of the bead-lifting lever.
The machine operates according to a totally innovative principle and envisages:
- A wheel positioning system that refers to the inside face of same and to the machine
turntable ( for rims with channel on inside, an optional reverse rim kit is available
).
- An effective manual wheel clamping system which, by means of pistol and cones
exploits the centre hole of the rim (for rims without hole an optional clamping kit
is available.)
- Pneumatic bead breaker unit consisting of two bead-breaker disk arms. Vertical
movement is pneumatic and independent, controlled from the control panel. The
horizontal positioning of the disks is manual with pneumatic operation from the
control panel and permits the simultaneous positioning of the bead-breaker disks.
Bead breaking is ensured by the movement of the disk with controlled hold-to-run
control.
- A tool head positioned on a rear-opening moving pole is made up of a fixed support-
ing nucleus for mounting and a moving nucleus hinged to the fixed part for perfect
demounting without having to use the bead-lifting lever*
* In a very few cases, a manual "help" accessory supplied as standard may be of use in simplifying de-
mounting where excessive lubricant has been applied and/or where tyres are combined with unusual rims
- A lifting unit (optional) with pneumatic pedal control for loading and unloading the
wheel from work position
Thanks to this machine, the following goals are also achieved:
- Reduction of the physical effort on the part of the operator
- Protection of the rim and tyre
Each machine features a plate showing identification details and a number of technical
details.
As well as the manufacturer's details, it carries: Mod. - Machine model; V - power supply voltage in
Volts; A - Current absorption in Amps; kW - Power absorption in kW; Hz - Frequency in Hz; Ph - Number
of phases; bar - Operating pressure in bar; Serial N. - Machine serial number; ISO 9001 - Guarantee
of certification of the company Quality System; CE - CE mark.
WARNING
Modifying or removing the data shown on the plate is forbidden.
Operator's manual Artiglio 500
EN
53