Warning; Camera Connection Failed - Ottobock 743L500 3D L.A.S.A.R. Posture Instrucciones De Uso

Use

5.4.6 Warning

Warning
Measuring accuracy too low.
Realign the measurement plate.
0.0 Nm 0.0 Nm
0.0 % 0.0 %
Warning
Measuring accuracy too low.
Realign the measurement plate.
Cancel

5.4.7 Camera connection failed

Camera connection failed
Please check the cables between the PC and the
cameras
0.0 Nm 0.0 Nm
0.0 % 0.0 %
Camera connection failed
Please check the cables between the PC and the
cameras
86
Live view Live view
Calibration failed. Tap to recalibrate... Calibration failed. Tap to recalibrate... tion failed. Tap to recalibrate...
Cancel Recalibrate
0.0 Nm 0.0 Nm
0.0 % 0.0 %
1
2
Recalibrate
Live view Live view
OK
0.0 Nm 0.0 Nm
0.0 % 0.0 %
1
2
OK
Error message text:
: "Warning"
: "Measuring accuracy too low."
: "Realign the measurement plate." – Position the
force measurement plate closer to the camera stand to
use the full camera resolution.
: "Cancel"
: "Recalibrate"
Possible causes:
• Force measurement plate rotated too much relative
to the camera
• Camera stand tilted away from the force measure­
ment plate too much
• Camera too far away from the force measurement
plate
Measures:
► Carry out the appropriate measures depending on
the cause (for example align the force measurement
plate and camera stands so that all LEDs are recog­
nised within the outer blue frame, that the
crosshairs of the inner blue frame are centred over
the middle of the force measurement plate, and that
the hinges on the force measurement plate are
aligned with one of the two centre lines of the
crosshairs; align the camera at a 90° angle; reduce
the distance between the camera and force meas­
urement plate).
► 1x tap on "Recalibrate".
Error message text:
: "Camera connection failed"
: "Please check the cables between the PC and the
cameras"
: "OK"
Possible causes:
• USB plug not connected to mini-computer
• Mini-computer software has crashed
• Defective cable
• Defective camera
Measures:
► Carry out the appropriate measures depending on
the cause (for example connect USB plug; restart
the mini-computer; have defective components
repaired by Ottobock Service).
► 1x tap on "OK".
743L500 3D L.A.S.A.R. Posture