Obligation signs
en
Wear eye
Wear a hard
protection
Wear
breathing
protection
Symbols
Read the
Return waste
operating
material for
instructions
recycling.
before use
Volts
Direct
current
Revolutions
Diameter
per minute
2 Description
2.1 Use of the product as directed
The TE 4-A18 is a hand-held, cordless rotary hammer for drilling in concrete, masonry, steel and wood and for driving
and removing screws.
Use only the batteries and chargers recommended by Hilti.
The power tool may be used only in a dry environment.
Do not use the power tool where there is a risk of fire or explosion.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
Modification of the power tool or tampering with its parts is not permissible.
Do not use the battery as a power source for other unspecified appliances.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
2
Wear ear
hat
protection
Drilling
without
hammering
Rated speed
under no
load
Forward /
reverse
Location of identification data on the power tool
The type designation can be found on the type identifica-
tion plate and the serial number on the side of the motor
housing. Make a note of this data in your operating in-
structions and always refer to it when making an enquiry
to your Hilti representative or service department.
Wear
protective
Type:
gloves
Generation: 01
Serial no.:
Hammer
drilling
Revolutions
per minute