Sennheiser EM 3731 Instrucciones De Uso página 85

00:1B:66:00:00:01
Standby
save
DEV 790.800
M
H z
sync
03.03
BANK AF
COM
esc
CH
Reset to
factory defaults ?
save
DEV 790.800
M
H
z
sync
03.03
BANK
AF COM
esc
CH
To automatically obtain an IP address (dynamic IP addressing):
Change to the setting mode of the "IP-Addr" menu.
The first byte starts flashing.
Press the jog dial
Press the save
Switch the receiver off and on again (see "Switching the receiver on/
off" on page 19).
The new IP address becomes effective.
Displaying the network address (MAC address)
MAC Via the "MAC" menu, you can display the Media Access Control (MAC)
address of the Ethernet interface. The MAC address is fixedly stored in
each receiver and cannot be changed.
Change to the setting mode of the "MAC" menu.
The 12-digit MAC address is displayed.
00 1B
66 00
00 01
Setting a receiver to standby mode
You can set a receiver to standby mode and mute it. To do so, proceed as
follows:
Change to the setting mode of the "Standby" menu.
The icon and the green backlighting of the
OFF
Press the save
digital audio
The esc button
processing
and the display is switched off.
sync
Note:
The standby mode remains active even when you switch the receiver
off and on again.
To end the standby mode:
Press the jog dial
The display is switched on.
Loading the factory-preset default settings
Reset Via the "Reset" menu, you can reset the current settings to the factory-
preset default settings.
Change to the setting mode of the "Reset" menu.
The question "Reset to factory defaults?" appears. The green
000
backlighting of the
Press the save
The factory-preset default settings are loaded. The display changes to
the selection mode of the operating menu.
digital audio
processing
sync
7
several times until the arrow points to "Auto".
8
button .
8
button .
6
is backlit in red. The receiver is set to standby mode
7 6
or the esc button .
8
save button flashes.
8
button until the progress bar is complete.
The operating menu
8
save button flash.
37