Lighting And Shutdown - Ferroli FORCE W 60 Instrucciones De Uso

1.3 Lighting and shutdown

Boiler lighting
Press the On/Off button (detail 14 - fig. 1).
Press the contextual button 1 to select the language, confirming it by pressing "OK".
Press the contextual button 3 to stop FH mode.
If none of the two selections described above is made, proceed as follows.
• For the following 300 seconds the display will show FH which identifies the heating system air venting cycle.
• The display also shows the firmware version of the cards.
• Open the gas cock ahead of the boiler.
• When the message FH disappears, the boiler is ready to operate automatically in case of a room thermostat demand.
Settings
Contrast adjustment
To adjust the display contrast, press the contextual button 2 and the OK button together. Then press the button ref.
5 of fig. 1 to increase the contrast or the button ref. 7 of fig. 1 to decrease it.
Setting the Date and Time
Reach the screen shown in fig. 8, navigating in the menu and following the path "USER MENU
Setting". Press the navigation buttons 5 and 7 to select the value and modify it with the contextual buttons 1 and 2. Con-
firm with the OK button.
194
Display v.01
Burner Controller 1 v.01
fig. 7 - Boiler lighting
Set date
24 / 09
2013
to select
to confirm
fig. 8 - Setting the Date
cod. 3541Q760 - Rev. 00 - 02/2019
FORCE W
"Settings" "Date
EN