Lighting And Shutdown; Date And Time Adjustment - Ferroli MACH Instrucciones De Uso

1.3 Lighting and shutdown

Boiler lighting
Press the On/Off button (detail 14 - fig. 1).
Display v.01
Modules: X
fig. 9- Boiler ignition (X indicates the num-
ber of burners)
By pressing contextual button 1 it is possible to choose the desired language and confirm it with the "OK" button.
By pressing contextual button 3 it is possible to interrupt the FH mode.
If neither of the two choices described above is made, continue as follows.
• For the following 300 seconds the display will show FH which identifies the heating system air venting cycle.
• The display also shows the firmware version of the cards.
• Open the gas cock ahead of the boiler.
• When the message FH disappears, the boiler is ready to operate automatically in case of a room thermostat request.
Settings
Contrast adjustment
To adjust the display contrast, press the contextual button 2 and the OK button together. Then press the button ref.
5 of fig. 1 to increase the contrast or the button ref. 7 of fig. 1 to decrease it.

Date and Time Adjustment

Reach the screen shown in fig. 10, navigating in the
menu and following the path "USER MENU
tings" "Date Setting". Press navigation buttons 5
and 7 to select the value and modify it with contextual
buttons 1 and 2. Confirm with the OK button.
298
X = 2 - MACH 150
X = 3 - MACH 225
X = 4 - MACH 300
X = 5 - MACH 370
X = 6 - MACH 450
X = 7 - MACH 520
X = 8 - MACH 600
"Set-
fig. 10- Date Adjustment
cod. 3541V120 - Rev 00 - 09/2021
Set date
24 / 09
2013
to select
to confirm
MACH
EN