Making A Miter Cut - RIDGID R4512 Manual Del Operador

Sierra de mesa de 254 mm (10 pulg.)

Tabla de contenido

Idiomas disponibles

OPERATION

MAKING A RIP CUT

See Figure 60.

WARNING:

Make sure the blade guard assembly is installed

and working properly to avoid serious possible

injury.

WARNING:

Taper cuts must only be made with a special jig,

which is commercially available. Do not attempt

a freehand taper cut on this saw. Failure to follow

these instructions could result in serious personal

injury.

 Set the blade to the correct depth for the workpiece.

 Position the rip fence the desired distance from the blade

for the cut and securely lock the handle.

 When ripping a long workpiece, place a support the same

height as the table surface behind the saw for the cut

work.

 Install feather board in the appropriate position for the

cut being made.

 Make sure the wood is clear of the blade before turning

on the saw.

 Turn the saw on.

 Position the workpiece flat on the table with the edge

flush against the rip fence. Let the blade build up to full

speed before feeding the workpiece into the blade.

 Using a push stick and/or push blocks, slowly feed the

workpiece toward the blade. Stand slightly to the side of

the wood as it contacts the blade to reduce the chance

of injury should kickback occur.

 Once the blade has made contact with the workpiece, use

the hand closest to the rip fence to guide it. Make sure

the edge of the workpiece remains in solid contact with

both the rip fence and the surface of the table. If ripping

a narrow piece, use a push stick and/or push blocks to

move the piece through the cut and past the blade.

 When the cut is made, turn the saw off. Wait for the

blade to come to a complete stop before removing the

workpiece.