Making Cuts - RIDGID R4512 Manual Del Operador

OPERATION
 If the back of the blade was too far from the miter gauge
groove, move the motor and blade assembly to the right
(away from the blade and wrench storage area) until the
blade is square. Retighten the bolts.
 If the back of the blade was too close to the miter gauge
groove, move the motor and blade assembly to the left
(toward the blade and wrench storage area) until the blade
is square. Retighten the bolts.
 After all bolts have been retightened, ensure that the blade
is aligned by verifying that the distance at the front and
rear of the blade are the same.
WARNING:
To reduce the risk of injury from kickback, align
the rip fence to the blade following any blade
adjustments. Always make sure the rip fence
is parallel to the blade before beginning any
operation.

MAKING CUTS

This table saw can perform a variety of cuts that are not all
mentioned in this manual. DO NOT attempt to make any cuts
not covered here unless you are thoroughly familiar with the
proper procedures and necessary accessories. Your local
library has many books on table saw usage and specialized
woodworking procedures for your reference.
The blade provided with the saw is a high-quality combination
blade suitable for ripping and cross cut operations. Carefully
check all setups and rotate the blade one full revolution to
assure proper clearance before connecting saw to power
source. Stand slightly to the side of the blade path to reduce
the chance of injury should kickback occur.
WARNING:
Do not use blades rated less than the speed of
this tool. Failure to heed this warning could result
in personal injury.
RULER
RULER
37 - English
BLADE
TOOTH
MITER GAUGE
GROOVE
Fig. 56
MITER GAUGE
GROOVE
Fig. 57