Making A Dado Cut - RIDGID R45171 Manual Del Operador

OPERATION
Once all non-through cuts are completed:
 Unplug your saw.
 Reinstall the riving knife in the "up" position then install
the blade guard and anti-kickback pawls.

MAKING A DADO CUT

See Figure 46.
An optional dado throat plate is required for this procedure
(see the Accessories section of this manual and check with
the retailer where the table saw was purchased). All blades
and dado sets must not be rated less than the speed of this
tool. This saw is designed for use with a 6 in. stack dado (up
to width of 3/4 in.). Do not use an adjustable dado on this saw.
WARNING:
When making a non-through cut, the blade is
covered by the workpiece during most of the cut.
Be alert to the exposed blade at the start and
finish of every cut to reduce the risk of personal
injury.
WARNING:
Always put all blade washers, spacers, and nuts
in proper location when changing back to saw
blade. Failure to do so may result in possible
injury and damage to the tool.
WARNING:
Always use push blocks, push sticks, and/or
featherboards when making dado cuts to avoid
the risk of serious injury.
 Unplug your saw.
 Remove the blade guard, anti-kickback pawls, throat
plate, and riving knife.
 Remove the blade nut, outer blade washer, saw blade,
inner blade washer, and spacer (see figure 48).
NOTE: Always store the blade washer and throat plate
in a secure location.
 Reinstall the inner blade washer.
 Mount the dado blade, according to manufacturer instruc-
tions, using the blade and chippers appropriate for the
desired width of cut.
 Reinstall the blade nut.
NOTE: The blade washer may be used provided the arbor
shaft extends slightly beyond the arbor nut.
 Make sure the blade nut is fully engaged and the arbor
extends past a securely tightened blade nut.
 Place riving knife release lever in locked position.
 Install the dado throat plate and rotate the blade by hand
to make sure it turns freely then lower the blade.
 Depending on the shape and size of the wood, use either
the rip fence or miter gauge.
 If making a rip cut, install feather board in the appropriate
position for the cut being made.
 Turn the saw on.
NOTE: Make sure the wood does not touch the blade
before you turn on the saw. Let the blade build up to full
speed before feeding the workpiece into the blade.
 Position the workpiece flat on the table with the edge
flush against the rip fence or miter gauge.
 Use a push block or push stick to move the wood through
the cut past the blade. Never push a small piece of wood
into the blade with your hand, always use a push stick.
The use of push blocks, push sticks, and featherboards
are necessary when making non-through cuts.
 When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.
Once all dado cuts are completed:
 Unplug your saw.
 Remove the dado blade and reinstall the standard cutting
blade.
 Reinstall the riving knife in the "up" position then install
the blade guard and anti-kickback pawls.
35 − English