Armrests; Battery Charger - Vermeiren TRACER Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 152
E
L
Make sure that the footplate is at least 6 cm above the ground to avoid scraping the ground
when moving. This could damage the wheelchair and endanger its operational safety. The
user might also get hurt.
L
Do not stand on the footplates; they are only designed for letting your feet rest on
them.
L
When the leg supports are adjusted, no persons or parts should be within their reach,
otherwise there is danger of injury and/or damage.
If there are patterns of illness and/or disabilities which mean there is no guarantee that your legs
would rest constantly on the leg supports, you may select from other available leg supports. Kindly ask
your specialist dealer if you have queries in this regard.

ARMRESTS

Frame
L
Never pick the wheelchair up for transportation by grasping the armrests, but take hold of solid
frame parts only.
The armrest containing the steering electronics can only be detached if the electronics have been
removed previously.
L
The armrests may only be removed when there is no chance of the wheelchair user
falling out sideways.
If changes, damage, or wear of the suspension are noticeable, kindly consult your specialist dealer
who can remedy these defects.
L
To avoid endangering your safety, do not use the wheelchair if you see that the mountings have
changed, been damaged, or have worn out.
L
If you make any changes to the armrests and/or the armrest retainers, you do so entirely at
your own risk. Then your insurance claims lapse immediately.

BATTERY CHARGER

To charge the batteries, only use the battery charger supplied - IMPULSE S (8 A).
Primary voltage
Secondary nominal voltage
Secondary maximum voltage
Secondary power
Battery type
Battery capacity
Safeguards
Nominal output
Efficiency
The height of the armrests can be adjusted by
loosening screw (1) and pulling the armrest
upwards.
To adjust the width between the armrests, you only
have to loosen screw (2) and place the armrest in
the desired position. The screw must be tightened
properly afterwards.
L
Make sure that all fixing screws are properly
2
tightened
otherwise injury and/or damage can be
1
caused.
230 Vac – 50/60 Hz – single phase
24 V
35 V
max. 8 A
Lead-sulphuric acid: gel
60 Ah – 85 Ah
Protected against reverse polarisation, electrical
surges and extreme temperature
270 W
min. 80% (when fully loaded)
12
before
using
the
wheelchair,
(80% capacity charged within 8 hours)
TRACER
01/2010
Tabla de contenido
loading

Tabla de contenido