Maintenance; Maintenance And Checks Of The Safety Devices On The Product; To Clean The Battery And The Battery Charger - Husqvarna K 535i Manual Del Usuario

Introduction
WARNING: Read and understand the safety
chapter before you do maintenance work on
the product.
WARNING: Remove the battery before you
do maintenance on the product.
WARNING: Failure to do maintenance
correctly can decrease the product life cycle
and increase the risk of accidents. All
servicing and/or repair work must also be
done by a professional. Turn to your
servicing dealer for more information.
Maintenance and checks of the
safety devices on the product
To do a check of the power trigger lockout
1. Make sure that the power trigger and power trigger
lockout move freely and that the return spring works
correctly.
2. Press down the power trigger lockout and make sure
that it goes back to its initial position when you
release it.
20

Maintenance

3. Make sure that the power trigger is locked at the idle
position when the power trigger lockout is released.
4. Start the product and apply full power.
5. Release the power trigger and make sure that the
cutting blade stops. If the cutting blade rotates when
the power trigger is in the idle position, turn to your
servicing dealer.
To do a check of the keypad
1. Start the product. See
trigger lockout on page 20
2. Press the start/stop button again.
3. Make sure that the product stops when you press
and hold the button. The green LED will go off.
To clean the battery and the battery
charger
• Make sure that the battery and the battery charger
are clean and dry before you put the battery into the
battery charger.
• Clean the battery terminals with compressed air or
use a soft and dry cloth.
• Clean the surfaces of the battery and the battery
charger with a soft and dry cloth.
To do a check of the power
CAUTION: Do not clean the battery or the
battery charger with water.
745 - 008 - 12.11.2018