Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Before starting
•
Important Read the section 'Operation' in this manual.
•
Read through the manual supplied with the power
pack before starting to use the machine.
•
Enclose the area to be cut so that unauthorised
persons can not be injured or disturb the operator.
•
Check that the blade and the blade guard is not
damaged or cracked. Replace the blade or the blade
guard if it has been exposed to impact or is cracked.
•
If cutting is to begin in another position than where the
saw unit is located, run the saw unit to the start
position.
•
Make sure that the sawing system is correctly
mounted and that the wall brackets, rails, blade bolt
and locking wheels are securely tightened and that
there are end stoppers mounted on the ends of the
rail.
Remote control
The sawing unit is controlled with the remote control,
which is equipped with radio communication for the power
unit and may therefore be used without a cable for optimal
mobility and supervision during the sawing process.
•
Turn off the remote control by pressing the "ON/OFF"
button.
OK
ON/OFF
0
•
Longitudinal feed, the dial guides the saw unit's
movement along the rail.
OK
ON/OFF
0
•
Arm feeding, the dial guides the pivot arm's movement
for changing of the cutting depth.
OK
ON/OFF
0
20 – English
STARTING AND STOPPING
•
Rotation of the blade, controls the blade speed. Back
arrow button, is used as a double command when
starting the blade's rotation. Start the rotation of the
blade by holding in the 'back' button while turning the
rotation control clockwise. The rotation speed is
controlled with a dial.
OK
ON/OFF
0
•
To switch off the blade rotation, turn the blade rotation
control anti-clockwise back to its zero position.
OK
ON/OFF
0
•
Stop button
OK
ON/OFF
0
Refer to the manual for the PP 220 for the remote control's
other settings and functions.
Starting
•
Activate the power unit by connecting it to a power
source and make sure that the RCD and emergency
stop are activated.
•
Activate the remote control by pressing the "ON/OFF"
button.
OK
ON/OFF
0
Capítulos
Tabla de contenido
