Flush Cutting; Connect The Power Pack - Husqvarna WS220 Manual De Instrucciones

Flush cutting

In order to cut flush against a perpendicular surface, it is
possible to attach the blade with six recessed screws
directly to the inner blade flange. This must be done before the saw is mounted on the rail, and is best done
when the saw is mounted on the transport trolley.
Adjust the wall brackets' distance to the cutting line to
approximately 85-90 mm from the cutting line during
assembly for flush cutting. A special flush cutting blade
guard should be used for flush cutting.
• Remove the blade bolt and the outer blade flange.
• Clean the clamping surface on the inner blade flange
and check that it is free from grades.
• Remove the six plugs that protect the screw threads
from dirt.
• Center the blade on the guide shoulder and press
onto the inner flange.
• Screw on the six included flush cutting screws (MF6S
8x12 10.9 FZB) and tighten crosswise to 30 Nm.
• Assemble the saw with blade on the rail and then
adjust the position and angle of the rail after how the
blade makes contact to the opposite surface.
• Before cutting is begun, the saw should be fed along
the entire length of the planned cut, this in order to
check the blade's distance and angle, as well as any
uneven parts on the opposing surface.
• Mount the flush cutting guard and make sure that the
blade moves freely in the guard.
• Connect the water hose between the outgoing water
supply connection on the saw body to the water
connection on the guide flange.
ASSEMBLING AND ADJUSTMENTS

Connect the power pack

IMPORTANT! This machine is only intended for use
together with the Husqvarna PP 220 power unit. All
other use is forbidden.
Read through the manual supplied with the power pack
before starting to use the machine. Follow the
instructions of the chapter 'Menu system' in the PP 220
manual.
• Connect the water hose from the power unit to the
inbound water supply connection on the saw unit.
• Connect the power cable between the power unit's
upper connection device, which is a power connector
for the WS 220, and the saw unit's power connection,
then connect the guard lids with each other to prevent
dirt from getting into the lids.
• Activate the power unit and start the remote control,
make sure that the remote control contacts the power
unit via radio communication or through the CAN
cable. Follow the instructions in the manual supplied
with the power pack.
–
English 19