Troubleshooting - Hilti PR 300-HV2S Manual De Instrucciones

4. With the aid of the receiver, mark point (A) low on
the wall.
5. With the aid of the receiver, mark point (B) at a
height of approx. 10 m.
6. Pivot the tool through 180° and realign it with the
reference point (R) on the floor and with point (A) at
the base of the wall.

8 Troubleshooting

Every item shown in the display is accompanied by either the "Information" or the "Warning" symbol (see section
"Overview of general symbols").
Message displayed
Inclination angle too high.
Rotating laser in wrong
position.
Rotating laser shock
Surveillance interrupted
Receiver battery symbol
Rotating laser battery
symbol
Tripod battery symbol
Autoalignment
Auto E-targeting
Autoalignment not pos-
sible
Fault
The tool cannot achieve
the given inclination.
The tool cannot level it-
self.
The tool has been subjec-
ted to shock.
Surveillance between the
tool and the laser receiver
has been interrupted.
The receiver's battery is
almost empty.
The rotating laser's bat-
tery is almost empty.
The tripod's battery is al-
most empty.
The Autoalignment pro-
cess was canceled.
Auto E-targeting cannot
be started.
Autoalignment is not pos-
sible at the moment.
7. With the aid of the receiver, mark point (C) at a
height of approx. 10 m.
8. Check the distance between points (B) and (C).
When the procedure has been carried out carefully,
the horizontal distance between the two points (B)
and (C) marked at a height of 10 meters should be
less than 1 mm (at 10 m).
NOTE If the deviation is greater: Please return the
tool to Hilti Service for calibration.
Possible cause
Inclination angle too high
The tool is not correctly
positioned – is already too
steeply inclined.
The rotating laser has
been subjected to shock
– accuracy can no longer
be guaranteed.
The receiver has received
no laser beam for more
than 2 minutes.
The receiver's battery is
almost empty.
The rotating laser's bat-
tery is almost empty.
The tripod's battery is al-
most empty.
The receiver could find
no laser beam within 2
minutes.
The receiver is outside the
Auto E-targeting range.
Autoalignment is not pos-
sible while certain menu
items are being executed.
Remedy
Reposition the tool so
that the inclination value
you have entered can be
achieved.
The tool must be reposi-
tioned in order to bring it
within the leveling range.
Restart the system and
take a reference measure-
ment before continuing
your work.
The tool must be restar-
ted and alignment of the
vertical laser beam then
carried out again.
Charge the battery soon.
Charge the battery soon.
Charge the battery soon.
The process must be re-
started.
Hold the receiver within
the laser beam.
Close the current menu
and try again.
45
en