Idiomas disponibles
Idiomas disponibles
EN
right at the trunk to a depth equal to 1/3 of the branch diameter. Finish the process by cutting the branch at the trunk from above.
Do not cut the branches by cutting from the bottom (XI).
If the power saw gets stuck while cutting, never leave it in this position with the motor running. Turn off the power saw motor,
unplug the power saw from the power supply, and use wedges to extract the power saw from the trunk.
When cutting a tree that has already been felled into pieces, follow the rules indicated below. Place the wood on the saw-horse or
a stand so the cut piece can freely fall to the ground without causing the power saw to jam. If the power saw is jammed, proceed
as described above. Do not touch the ground with the power saw or allow it to be contaminated with soil.
When working on a slope, stay above the cut wood.
Exercise particular caution when cutting a tensioned tree and entrust this activity to a qualifi ed lumberjack, if possible. When
cutting tensioned wood and supported on both ends, cut it from above to a depth of 1/3 of the diameter, and then fi nish the cut
from the bottom.
If the wood is supported only at one end, cut the wood from the bottom to a depth equal to 1/3 of the diameter, and then fi nish the
process by cutting from the top (XII).
This will reduce the risk of the power saw jamming during cutting.
PRODUCT MAINTENANCE AND STORAGE
Caution! Before starting any activities described below, disconnect the power saw from the power supply. Disconnect the
mains-powered power saws from the socket. In the case of the battery-powered power saws, disconnect their battery.
After each use, inspect the condition of the power saw with particular attention to the patency of ventilation openings.
Check the placement of all of the power saw's components. Tighten all loose screw connections, if any. Check the tension and
condition of the chain. If any damage is observed, replace the chain with a new one. It is forbidden to use the power saw with a
damaged chain!
If the chain is too loose, it may fall from the guide bar, which may cause injury to the person operating the power saw. The chain
must also be properly sharpened, because it requires appropriate experience and tools. It is recommended to carry out sharpen-
ing at specialised service centres. Clean the power saw's housing with a soft, dry cloth. Clean the housing from residues of wood,
oil, grease, and other contaminants. Coat the chain with a thin layer of oil or preservative agent. The power saw should be stored
in a dry, closed room, disconnected from the mains.
Store the power saw in shaded and dry places with appropriate ventilation preventing steam condensation. Such a place should
not be accessible to unauthorised persons, especially children. During storage, the guide bar and chain must always be secured
with a guard.
O R I G I N A L
I N S T R U C T I O N S
22
