Idiomas disponibles
Idiomas disponibles
4. Start the engine and increase the engine speed
to full engine speed.
5. Do a check if the axle turns.
6. If the axle does not turn, do the steps that follow:
a) Stop the engine.
b) Install the control linkage to the control arm
(A).
7. If the axle turns, do the steps that follow:
a) Use a 1/4-in hex key to loosen the
adjustment screw (B) to make it possible to
adjust the control arm (A).
b) Move the control arm until the wheel does not
turn.
c) Torque the adjustment screw to 180-220 in-lb
(20.3-24.9 Nm).
d) Make sure that the wheel does not turn.
e) Stop the engine if the wheel does not move.
f) Install the control linkage to the control arm
(A).
8. Adjust the neutral position of the wheel on the
opposite side of the product if it is necessary.
9. Remove the support and lower the product.
To do a check of the neutral
switches
1. Engage the parking brake.
2. Remove the operator cushion.
3. Do a check of the left and right neutral switch
mechanism.
4. Make sure that the control levers are in the
neutral position.
5. Adjust the neutral switch mechanism if the roller
is not in the groove on the bellcrank. Refer to
adjust the neutral switches on page 21 .
To adjust the neutral switches
1. Engage the parking brake.
2. Remove the operator cushion.
3. Remove the lower bolt on the bellcrank.
4. Rotate the bellcrank until the roller is in the
groove.
2374 - 005 - 16.07.2024
5. Install the bolt in the hole that aligns with the
control rod.
6. Make sure that the engine starts.
7. Adjust the tracking speed. Refer to
tracking speed on page 14 .
To examine the blades
CAUTION:
balanced blades can cause damage to
the product. Replace damaged blades.
Let an approved service agent help you
sharpen and balance blunt blades.
•
Look at the blades to see if they are damaged
and if it is necessary to sharpen them.
To replace the blades
1. Remove the blade bolt.
2. Assemble the new blade with the side without
stamps in the direction of the cutting deck.
3. Attach the blade bolt. Torque the bolt to 90 ft-lb /
122 Nm.
To remove the deck drive belt
1. Park the product on level ground and engage the
parking brake.
2. Lower the cutting deck into the lowest mow
position.
To
3. Move the belt tensioner to the left side of the
frame to release the belt tension.
4. Remove the deck drive belt from around the
clutch pulley and the stacked pulley in the front
of the cutting deck.
To install the deck drive belt
1. Install the deck drive belt around the clutch pulley
and the stacked pulley in the front of the cutting
deck.
Damaged or incorrectly
WARNING:
Incorrect blade type
can cause objects to eject from
the cutting deck and cause serious
injury. Use only approved blades.
To adjust the
21
