Idiomas disponibles
Idiomas disponibles
•
Use oil when you lubricate with an oil can.
•
When you lubricate with grease, use a chassis
or ball bearing grease that prevents corrosion.
Remove unwanted grease after lubrication.
•
Lubricate 2 times a week if you operate the
product daily.
•
Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean
with alcohol. If the friction between the drive belt
and the pulley is not sufficient after you clean
with alcohol, replace the drive belt.
CAUTION:
other petroleum products to clean drive
belts.
To do a check of the transmission oil
level
Note:
Do the transmission oil check when the
transmission is cool.
1. Put the product on a horizontal surface.
2. Loosen the knob and tilt the pump cover for the
hydraulic tank.
3. Turn the oil cap (A) counterclockwise and
remove it.
A
24
Do not use gasoline or
4. Do a check of the hydraulic oil level. The
hydraulic oil level must be between the 2 holes
(B) inside the oil tank (B).
5. Fill the hydraulic tank with hydraulic oil if
necessary. Use correct transmission oil type,
Technical data on page 31 .
refer to
6. Install the oil cap.
7. Install the pump cover for the hydraulic tank.
Tighten the knob fully.
To replace the hydraulic oil and the
oil filter
WARNING:
becomes very hot during operation and
can cause burn injuries. Let the product
become cool before you drain the oil.
WARNING:
If you spill engine oil on your body, clean
with soap and water.
1. Park the product on level ground and stop the
engine.
2. Loosen the knob and tilt the pump cover for the
hydraulic tank.
3. Clean the area around the oil openings in the
hydraulic oil tank.
B
The hydraulic oil
Use protective gloves.
2374 - 005 - 16.07.2024
