Idiomas disponibles
Idiomas disponibles
To do a check of the RCD, 3 phase
1. Start the product. Refer to
page 32 .
2. Look into the inspection holes and push the RCD
test button (A).
A
B
3. Make sure that the RCD breaker moves to the left
(B) and thereby disconnects the product from the
power supply.
4. Make sure that the saw blade stops. Also make sure
that all LED lights on the power pack goes out.
5. Turn the RCD reset knob clockwise (A) to reset the
RCD breaker. Look into the inspection holes to make
sure that the RCD breaker is set to the right (B)
when the RCD reset knob bounces back to the left.
A
B
16
To start the product on
To do a check of the RCD, 1 phase
When the Power Pack is plugged in to a 1 phase
connection, the RCD integrated to the power pack is
not active. You instead need to use a separate 1 phase
adapter.
1. Connect the product to the outlet. Use the correct
Accessories on page 61 .
adapter. Refer to
2. Push the RESET button (green). Make sure that the
red LED (A) lights up.
A
3. Start the product.
4. Push the TEST button (blue).
5. The RCD must trip, the product must stop
immediately and all LED ligths must go off. If not,
speak to your Husqvarna dealer.
6. Push the RESET button (green).
Blade guard
The blade guard keeps dust away from the operator and
prevents injury if the cutting blade breaks.
WARNING:
without a blade guard.
The outer sections can be removed for near floor
operations.
Blade guard lock
The blade guard lock keeps the blade guard guide in
the correct position on the blade guard. Make sure the
screw for the blade guard guide is fastened when the
blade guard is fitted.
Do not use the product
2092 - 002 - 15.01.2024
