Idiomas disponibles
Idiomas disponibles
Transporting the battery
1. Ensure the battery is in a safe condition.
2. Use non-conductive packaging when
transporting the battery.
3. The contained Li-Ion batteries are subject to the
dangerous goods legislation requirements.
Transport batteries only when the battery
housing is undamaged. Pack up the batteries in
such a manner that cannot move around in the
packaging.
SAW MAINTENANCE
Follow the maintenance instructions in this manual.
Proper cleaning of saw and chain and guide bar
maintenance can reduce chances of kickback.
Inspect and maintain saw after each use. This will
increase the service life of your saw. Once got wet in
the rain during operation, the machine and the battery
pack should be dried before storing or charging.
NOTE: Even with proper sharpening, risk of kickback
can increase with each sharpening.
MAINTENANCE AND
STORAGE OF CHAINSAW
1. Remove the battery pack
• When not in use
• Before moving from one place to another
• Before servicing
• Before changing accessories or attachments,
such as saw chain and guard
2. Inspect Chainsaw before and after each use.
Check saw closely if the guard or other part
has been damaged. Check for any damage that
may affect operator safety or operation of saw.
Check for alignment or binding of moving parts.
Check for broken or damaged parts. Do not use
Chainsaw if damage affects safety or operation.
Have damage repaired by authorized service
center.
3. Maintain Chainsaw with care.
• Keep chain sharp, clean, and lubricated for better
and safer performance.
• Follow steps outlined in this manual to sharpen
chain.
• Keep handles dry, clean, and free of oil and
grease.
• Keep all screws and nuts tight.
4. When servicing, use only identical replacement
parts.
5. When not in use, always store Chainsaw
• in a high or locked place, out of children's reach
• in a dry place
• with protective scabbard in place
BAR MAINTENANCE
To maximize bar life, the following bar maintenance is
recommended.
The bar rails that carry the chain should be cleaned
before storing the tool or if the bar or chain appear to
be dirty.
The rails should be cleaned every time the chain is
removed.
TO CLEAN THE BAR RAILS:
P
1. Remove drive cover and bar and chain. (see
section ASSEMBLY)
2. Using a wire brush, screwdriver or similar tool,
clear the residue from the inner groove of the bar.
(See Fig. P)
3. Make sure to clean oil passages thoroughly.
CONDITIONS WHICH REQUIRE CHAIN AND
GUIDE BAR MAINTENANCE:
• Saw cuts to one side or at an angle.
• Saw has to be forced through the cut.
• Inadequate supply of oil to the bar and chain.
Check the condition of the guide bar each time the
chain is sharpened. A worn guide bar will damage the
chain and make cutting difficult.
After each use, remove the battery pack, clean all
sawdust from the guide bar and sprocket hole.
When rail top is uneven, use a flat file to restore
square edges by removing any burrs from the side or
top of the bar.
File Rail Edges
and Sides
Square
Worn Groove
Replace the guide bar when the groove is worn,
the guide bar is bent or cracked, or when excess
heating or burring of the rails occurs. If replacement
is necessary, use only the guide bar specified for your
saw in the repair parts list or on the decal located on
the Chainsaw.
REPLACING BAR & CHAIN
Replace chain when cutters are too worn to sharpen
or when the chain becomes inoperable. Only use
replacement chain noted in this manual.
EN
Correct Groove
17
