Idiomas disponibles
Idiomas disponibles
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY
WARNING! Do not install the battery pack
before it has been completely assembled.
Always use gloves when handling the chain.
CHAIN AND GUIDE BAR ASSEMBLY
1. Unpack all parts carefully. Remove the drive cover
by turning the hex nuts in a counter-clockwise
direction. (See Fig. A1)
A1
2. Place the Chainsaw on a solid, level surface.
3. Use only genuine Kress chains or those
recommended for the Guide Bar.
4. Slide the chain in the slot around the guide bar.
Ensure the chain is in correct running direction by
comparing it to the chain icon, or referring to the
chain direction symbol found on the saw body.
5. Fit the chain onto the drive sprocket, so that the
two bar locating studs on the bar pad fit into the
keyway of the opening on the guide bar. Ensure
that the chain tension hole fits on the chain
tension pin.(See Fig. A2).
A2
25
6. Ensure all parts are seated properly and hold
chain and guide bar in a level position. Make sure
the drive links are fully seated in the drive sprocket
(See Fig. A3), avoiding a kink as shown in Fig. A4.
If kink occurs, pick up on the chain at the guide
bar just ahead of the kink and then pull the kink
out.
A3
A4
Kink/Plis/Torcimiento
23
NOTE: Chain should rotate freely and be free of
kinks.
7. Fit the drive cover and tighten the drive cover by
turning the hex nuts clockwise until it is slightly
tight. (See Fig. A5)
A5
2
1
EN
11
