Idiomas disponibles
Idiomas disponibles
E2
The Li-ion battery is protected against deep
discharging. When the battery is empty, the machine
is switched off by means of a protective circuit. Each
battery must be fully charged before the first use.
TO REMOVE OR INSTALL BATTERY PACK
(See Fig. F, G)
F
EN
G
Depress the battery pack release button to remove
the battery pack from your tool. After recharging,
insert the battery pack into the battery port. A simple
14
1
2
push and slight pressure will be sufficient until a click
is heard. Check to see if the battery is fully secured.
NOTE: When removing the battery pack, hold it
firmly to avoid dropping and injury.
SWITCHING ON AND OFF (SEE FIG. H)
H
ATTENTION: Check the battery packs before using
your cordless tool. Only use the battery pack listed
in the accessories section.
To switch on the tool, press the throttle lock-out
button, then fully press the throttle trigger and hold
in this position. The throttle lock-out button can now
be released. If the saw does not function, please see
CHAIN BRAKE LEVER information below.
For switching off, release the throttle trigger.
NOTE: The chain brake must be deactivate in order
for the saw to be switched on.
CHAIN BRAKE LEVER (See Fig. I)
I
Click/
Cliquez/Clic
1
2
The chain brake lever is a safety mechanism activated
through the front hand guard, when kickback occurs.
Chain stops immediately.
The following function check should be carried out
at regular intervals. Pull the front hand guard towards
the operator (position
To activate the chain brake, push front hand guard
forwards (position
)*.
NOTE:
1. If the saw is unable to start, even though it is
1
2
Click/
Cliquez/Clic
2
1
) to deactivate chain brake.
