Idiomas disponibles
Idiomas disponibles
WARNING: The chain is not yet tensioned.
Tensioning the chain applies as described
under "TENSIONING CHAIN". The chain
now needs to be inspected to make sure it is
properly tensioned.
TENSIONING CHAIN (See Fig. B, C)
B
C
EN
1. Lossen the nuts on the guide cover with wrench
as shown in Fig A1.But remember not to remove
the cover.
2. Lift the chain cover of guide bar and turn the
tensioning screw with a wrench in a clockwise
direction. Tighten the tensioning screw until the
chain is tensioned correctly and can still move
easily.(See Fig B&C)
3. Tighten the nuts on the drive cover with wrench as
shown in A5 until it is tight.
4. Double check the tension set by the chain
tensioning screw. The correct chain tension is
reached when the chain can be raised approx.
Half the drivelink depth from the guide bar in the
center. This should be done by using one hand to
raise the chain against the weight of the machine.
NOTE: The chain will stretch while cutting and lose
proper tension. When the chain becomes loose,
completely unscrew the hex nuts or turn the hex
nuts around three full turns in a counter-clockwise
direction, then re-tension the chain and tighten
the hex nuts to properly reset the chain tension by
repeating Steps 1-4 listed above.
12
LUBRICATION (See Fig. D)
0.12-0.2"
D
3-5mm
Guide Bar
and chain oil or allow the tank to become empty,
as this will result in extensive damage to the
product.
NOTE: Chain life and cutting capacity depend
on optimum lubrication. Therefore, the chain is
automatically oiled during operation.
FILLING OIL TANK:
1. Set Chainsaw on any suitable surface with oil filler
2. Clean area around the oil filler cap with cloth and
3. Add bar and chain oil until tank is full.
4. Avoid dirt or debris entering oil tank, refit oil filler cap
formulated to perform over a wide temperature
range with no dilution required. This can be found
at the location where you purchased this saw or
your local hardware store. Do not use dirty, used
WARNING:
Removing the battery pack before adjusting saw
chain tension.
Cutting edges on chain are sharp. Use protective
gloves when handling chain.
Maintain proper chain tension always. A loose
chain will increase the risk of kickback. A loose
chain may jump out of guide bar groove. This
may injure operator and damage chain. A loose
chain will cause chain, bar, and sprocket to wear
rapidly.
NOTE: The chain is properly tensioned when it
can be lifted off of the Guide Bar and the drivelink
is within the rail of the Guide Bar.
IMPORTANT: The Chainsaw is not filled with
oil. It is essential to fill with oil before use.
Never operate the Chainsaw without bar
WARNING: Removing the battery pack
before filling the oil tank.
cap facing upward.
unscrew the cap by turning it counter clockwise.
and tighten by turning clockwise until hand tight.
It is important to use bar and chain
lubricant (not automotive oil) that is
