Idiomas disponibles
Idiomas disponibles
or otherwise contaminated oils. Damage may
occur to the bar or chain.Use of non approved oil
will void the warranty.
Do not swallow any type of bar oil. If swallowed,
call a physician immediately. Keep out of reach of
children. Store away from heat or open flame.
CHECKING THE AUTOMATIC OILER
Proper functioning of the automatic oiler can be
checked by running the Chainsaw and pointing the tip
of the guide chain bar towards a piece of cardboard
or paper on the ground. If an increasing oil pattern
develops on the cardboard, the automatic oiler is
operating fine. If there is no oil pattern, despite a full
oil reservoir, contact Kress customer service agent or
Kress approved service agent.
NOTE: It make take an extended period of time (1
minute +) for the pump to prime when new or after
the saw has not been in use for an extended period
of time.
CAUTION: Do not touch the ground with the
chain. Ensure safety clearance of 6'' (15
cm).
BEFORE OPERATION
TESTING THE CHAINSAW AND BATTERY
Checking the controls
Throttle Lock-Out Button and Throttle Trigger
1. Remove the battery.
2. Try to press the Throttle Trigger. If the Throttle
Trigger can be pressed, the Throttle Lock-Out
Button is defective. Stop using the chainsaw and
contact the service agent.
4. Hold and press the Throttle Lock-Out Button first,
then press the Throttle Trigger.
5. Release the Throttle Trigger and the Throttle
Lock-Out Button. If the Throttle Trigger or the
Throttle Lock-Out Button is get stuck and cannot
spring back to its origianl position. Stop using the
chainsaw and contact the service agent.
OPERATION
BEFORE USING YOUR CORDLESS TOOL
WARNING! The charger and battery pack
are specially designed to work together so
do not attempt to use any other devices. Never
insert or allow metallic objects into your charger
or battery pack connections because of an
electrical failure and hazard will occur.
NOTE: Your battery pack is UNCHARGED and you
must charge once before use.
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another
battery charger.
CHECKING THE BATTERY CHARGE
CONDITION (See Fig. E1)
E1
Before starting or after use, press the power test
button on the battery pack to check the battery
capacity.
Note: Fig E1 only applies for the battery pack with
battery indicator light.
Remarks
LED light
Five green
lights are
illuminated.
Four green
lights are
illuminated.
Three green
lights are
illuminated.
Two green
lights are
illuminated.
One green
light is
illuminated.
One green
light is
flashing.
CHARGING YOUR BATTERY PACK (See Fig.
E2)
100%
0%
Battery condition
80% ≤ Power level ≤
100%
60% ≤ Power level < 80%
40% ≤ Power level < 60%
20% ≤ Power level < 40%
10% ≤ Power level < 20%
0% ≤ Power level < 10%
EN
13
