Idiomas disponibles
Idiomas disponibles
˜ Connecting via the AUX-in jack
NOTE: Music playback via the AUX-in jack 2 has a higher
priority over a Bluetooth
Once the AUX cable 12 is plugged into the AUX-in jack 2 ,
the Bluetooth
playback is now switched to AUX-in only and the LED 1 will
light up green.
If the product is off, press and hold the
LED 1 lights up green and a signal tone sequence sounds.
Switch the playback device on and start playback.
Adjust the volume on the playback device to the highest
possible volume then adjust the volume on the product using the
8
and
˜ Switching between AUX-in
and Bluetooth
To resume music playback via Bluetooth
AUX cable 12 from the AUX-in jack 2 . The product will then
search for the previously paired playback device (if any) and
re-establish the Bluetooth
˜ TWS pairing
NOTE: This function is only available if two of these products
have been purchased and both have the same model number.
Turn on both products and make sure they are both not
connected to another device via Bluetooth
Press the
then by default set it as the "master" unit. A beep will sound.
When pairing between both products has been carried out
successfully, the RGB light of the connected "slave" unit stops
flashing and a sequence of beeps will sound.
connection.
®
wireless connection will be disconnected. Music
®
6
buttons.
connections
®
®
button 5 on one of the products which will
®
connection automatically.
button 7 until the
connection unplug the
.
®
GB/IE
35
