Idiomas disponibles
Idiomas disponibles
(Fig. 22)
(Fig. 23)
A
(Fig. 6)
5.3 INSTALLATION OF THE AUXILIARY ROLLER FOR EDGING
INNER RADII AND INNER CORNERS AT 90°
The auxiliary roller comes pre-installed from the factory and
allows edging of inner corners at 90° (minimum radius 18 mm).
If it is necessary to disassemble and reassemble it, fix it as
shown in the figure. Insert the end of the roller shaft into the
corresponding plate hole (Fig. 22). Once positioned, proceed to
secure it by tightening the screw in the threaded hole (Fig. 23).
6. PORTABLE EDGEBANDER PEB250/250
RECOMMENDATIONS FOR GOOD EDGE ADHESION
The following are the most important recommendations for
consideration when using the PEB250, taking into account the
board, edge, glue and work temperature.
6.1 ABOUT THE EDGE AND BOARD
• The edge of the board to be banded must be at 90º to the
top surface and free of dust. For boards with an inclination of
up to 10º, see section 8.4 Inclined guide plate adjustment.
• The edge must have a good surface to obtain a perfect finish
when banding chip boards with thin edges and dust free.
• The pieces and the edges that are going to be glued must be
at a temperature of at least 18°C (64ºF).
• Always apply sufficient force on the edge to obtain a good
banding.
• For rigid (Formica) edges, sufficient pressure must be applied
to overcome the rigidity of the same.
• With porous boards, the amount of glue to be applied should
generally be increased.
6.2 ABOUT THE GLUE
• With rigid edges, it is preferable to reduce the temperature
by 10%; increasing the volume of glue is counter-productive
B
and does not necessarily achieve better quality adhesion.
• Make sure you have enough fully melted glue in the tank to
finish the job. If glue needs to be added to the tank for this,
activate the gluing speed some 5 minutes earlier (see section
9.2 Controlling the gluing speed).
• Degraded glue loses its adhesive properties and does not stick
properly. The colour of the glue tends to darken.
• When you are going to glue the edges, use Virutex special
glue for PEB250 (ref. 2599266), which has been specially de-
veloped for this purpose.
• You can also use one of the following glues which have been
approved by Virutex for use in the PEB250:
- Rayt type MA-6244
- Kleiberit 743.7
- Kleiberit VP9296/57
PEB250 EVOLUTION - 25
