Idiomas disponibles
Idiomas disponibles
Saw blades with fi ne teeth and low
number of strokes
• The jig saw can be easily guided by hand. In
the interest of clean saw cuts and optimum
sawing performance, make sure the feed
is adjusted to suit the material. The basic
principle here is: the harder the material, the
slower the feed!
• When sawing metals, a small amount of oil
should be applied to the cutting line.
• Thin sheet steel should be appropriately
clamped to a fi xed supporting surface (e.g.
plywood board): This minimises and prevents
vibrations and fl exing.
• When making inside cuts, drill a suffi ciently
large hole in the work piece being machined
in order to insert the saw blade.
• The parallel limit stop can also be used for
curved cuts. To do so, fasten a nail in the cen-
tre of the circle and use it as a pivot for the
limit stop. The scale for curved cuts is on the
underside of the stop rail.
6 Maintenance, cleaning and care
Caution!
Remove the battery from device before any
assembly, adjustment, maintenance measu-
re or repair!
Every tool is contaminated by dust or chips
while working. Cleaning is therefore essential.
To ensure a long service life, however, the ma-
chine should be cleaned with a soft cloth or
brush after each use.
Mild soap or other suitable cleaning agent may
be used in this context. Solvents or cleaning
agents containing alcohol (e.g. petrol, cleaning
alcohols etc.) should be avoided, since these
can attack plastic casings.
Always keep the apertures required for cooling
the motor free of dust and dirt.
Tip:Regularly apply a few drops of motor oil
(Fig. 7) to the piston and the support rollers af-
ter approx. 30 minutes of operating time.
Note!
Service note
Please note: The mains power input for the
charger may only be replaced by our Proxxon
Service Department or a qualifi ed specialist!
7 Accessories
The device, battery and charge are also separa-
tely available at retailers!
For more detailed information on accessories,
please request our appliance catalogue from
the address given in the warranty notice on the
last page or visit www.proxxon.com.
Please note in general:
Proxxon bits and cutters have been designed
to work with our machines, which makes them
optimal for their use.
We will not assume any liability whatsoever
for the safe and proper function of our devices
when using third-party bits and cutters!
8 Disposal
Please do not dispose of this machine
in household waste! The device con-
tains valuable materials which can be
recycled. If you have questions concer-
ning this topic, please contact your municipal
disposal company or other appropriate munici-
pal institutions.
Note on disposal within the EU:
Please note that in accordance with the EU
directive 2012/19/EU and the EU directive
2006/66/EC, defective or consumed accumula-
tors and no longer operational electrical devices
must be disposed of separately from household
waste and must be sent for reuse in an environ-
mentally responsible manner!
- 15 -
