MPL 111 S
GB
3.7 O
UTDOOR INSTALLATION
For units in outdoor installations, it is advisable to ensure
a position that provides maximum protection against
atmospheric agents, powder, etc.
Avoid direct exposure to sunlight that would otherwise
cause abnormal heating of the system.
It is advisable to protect the system with shed roof.
For temporary or short-term installations, the unit may
simply be placed on a flat surface.
For permanent or long-term installations, it is advisable
to prepare a concrete foundation.
The area where the power set is installed must be
suitably fenced off in order to prevent access by
unauthorized persons.
No admittance and Hazard signs must be installed
as required by current legislation.
GB
- 20
Outdoor installation
Key:
1 - Casing in painted sheet metal
2 - On board control panel
3 - Foundation
4 - Air expulsion
5 - Cable duct
6 - Air intake
7 - Gas exhaust pipe
8 - Metal protection enclosure
9 - Distribution panel not supplied as
standard (automatic start remote
control switches-Optional)