Idiomas disponibles
Idiomas disponibles
OPERATION
TO CHANGE BLADE DEPTH
See Figure 41.
The blade depth should be set so that the outer points of the
saw blade are higher than the workpiece by approximately
1/8 in. to 1/4 in. but the lowest points (gullets) are below
the top surface.
Unlock the blade height lock knob.
Raise the saw blade by turning the height adjusting knob
clockwise or lower it by turning the knob counterclockwise.
Once the desired saw blade height is achieved, lock the
blade height lock knob by turning it clockwise.
TO CHANGE BLADE ANGLE
See Figure 42.
NOTE: A 90° cut has a 0° bevel and a 45° cut has a 45° bevel.
Unplug the saw.
Unlock bevel locking lever by pulling the lever all the way
to the right.
Adjust the bevel angle, turning the handwheel
counterclockwise increases the angle of the blade, bringing
it closer to 45°. Turning it clockwise decreases the angle,
bringing the blade closer to 90°.
NOTE: When the bevel adjusting handwheel is pushed
back towards the saw housing and held in, the bevel angle
can be quickly changed by pushing the handwheel left
or right.
Lock bevel locking lever by pushing lever to the left.
TO ADJUST THE BEVEL INDICATOR
See Figure 43.
If the bevel indicator is not at zero when the saw blade is at
90°, adjust the indicator by loosening the screws and setting
at 0° on the bevel scale. Retighten the screws.
GULLET
TO LOCK
HEIGHT
ADJUSTING
KNOB
BEVEL
LOCKING LEVER
BEVEL
INDICATOR
32 − English
BEVEL
LOCKING LEVER
TO UNLOCK
BLADE HEIGHT
LOCK KNOB
DECREASE
TO
INCREASE
ANGLE
ADJUSTING
HANDWHEEL
SCREW
Fig. 41
TO
ANGLE
BEVEL
Fig. 42
Fig. 43
