Idiomas disponibles
Idiomas disponibles
CLEANING AND MAINTENANCE
Moving the Unit
Using the Wheels to Move the Unit
* Please lift up the front of the unit when moving it by holding the pipe section on
either side of the legrest.
* Please be careful because the unit is heavy.
* It is easier to move the unit with the massage heads retracted and the backrest
in the upright position.
* Place a mat on the floor and gently roll the unit over it to avoid damaging the floor.
* Do not move the unit while someone is seated on it.
* Please remove the control panel from the control panel stand.
* Please make sure the legrest slider is fully retracted when moving the unit.
Lifting the Unit
* Move the chair by having one person hold onto the pipe sections on either side
of the legrest and another person use the handles on the back.
* Please hold the handles and legrest securely to avoid dropping the unit as it
may damage your floor.
* Please make sure the legrest slider is fully retracted when moving the unit.
CAUTION
• Do not move the unit while someone is seated on it.
• When moving the unit using the wheels, remove all obstacles
from around it, make sure the backrest is in the upright position,
lift it no higher than waist height (no higher than 32 in. (80 cm))
and roll it slowly.
Failure to do so may cause the unit to tip over, which may lead to damage
or injury.
v_
J
Synthetic Leather on the Pillow, Back
Cushion and Armrests_
• Wipe these areas with a soft, dry cloth. (Do NOT use
cloths containing any kind of chemical, etc.)
• If the synthetic leather is particularly dirty, soak a soft
cloth in water or a 3~5% solution of mild detergent,
wring it out thoroughly and tap the surface with it. Next,
rinse the cloth in water, wring it out thoroughly and then
wipe any remaining detergent from the surface, wipe the
surfaces with a soft dry cloth and allow them to dry
naturally.
(Do NOT use a hair dryer to try to dry the surfaces more
quickly.)
* Do not allow the unit to be in contact with these areas
for extended periods of time as this may lead to
discoloration.
CAUTION
Always unplug the unit before cleaning it. Never
touch a power plug with wet hands.
Failure to follow these instructions may lead to
electrocution or burns.
v_
J
Pipe and Plastic Areas
(1) Wipe the unit with a cloth that
has been soaked in a mild
detergent and then
thoroughly wrung out.
(2) Next wipe the unit with a cloth
that has been moistened with
just water and thoroughly
wrung out.
* Make sure you thoroughly
wring out the cloth first when
cleaning the control panel.
(3) Allow the unit to dry naturally.
• Please do NOT use
thinners, benzene or alcohol.
Seat Fabric_
(1) Wipe the seat fabric with a
cloth that has been soaked in
a mild detergent and then
thoroughly wrung out.
(2) Use a mild detergent and
brush on areas where the
seat fabric has become
particularly soiled. Be careful
not to brush the fabric too
much as you may damage it.
(3) Next wipe the fabric with a
cloth that has been moistened with just water and
thoroughly wrung out.
(4) Allow the fabric to dry naturally.
28
