Idiomas disponibles
Idiomas disponibles
Adjust
the "LOW" setting of surface
burner valve (for linear flow valves only)
1.
Push in and turn knob to (lite) until burner ignites.
Push in and quickly turn knob to LOWEST
POSITION.
3.
If burner goes out, reset control to OFF and set to
low flame again.
Remove
the burner control knob.
Insert a thin-bladed screwdriver into the hollow
valve stem and engage the slotted screw inside
(See Fig. 36). Flame size can be increased or
decreased with the turn
of the screw. Turn coun-
terclockwise to increase flame size. Turn clockwise
to decrease flame size.
Fig. 36
After installation is complete, make all
controls are left in the OFF position.
12
Care, cleaning and maintenance
Refer to the Use & Care Guide for cleaning instructions.
If removing the range is necessary for cleaning or
maintenance, shut off the gas supply. Disconnect the
gas and electrical supply. If the gas or electrical supply
is inaccessible, lift the range slightly at the front and pull
out away from the wall. Pull only as far as necessary to
disconnect the gas and electrical supply. Finish removing
the range for servicing and cleaning.
Reinstall in reverse
order making sure to level the range and check gas
connections for leaks. See anti-tip instructions for proper
anti-tip anchoring instructions.
Before you call for service
Refer to the Use & Care Guide for cleaning instructions.
If removing the range is necessary for cleaning or
maintenance, shut off the gas supply. Disconnect the
gas and electrical supply. If the gas or electrical supply
is inaccessible, lift the range slightly at the front and pull
out away from the wall. Pull only as far as necessary to
disconnect the gas and electrical supply. Finish removing
the range for servicing and cleaning.
Reinstall in reverse
order making sure to level the range and check gas
connections for leaks. See page 5 and 6
of this document
for proper anti-tip anchoring instructions.
Model and serial number location
The Serial Plate is located on the right-hand surface of the
oven front frame at the storage or warmer drawer; or the
lower panel area (See Fig. 37).
Fig. 37
When ordering parts for or making inquires about your
range, always be sure to include the model and serial
numbers and a lot number or letter from the Serial Plate
on your range. The Serial Plate will also inform you of the
rating of the burners, the type of fuel and the pressure the
range was adjusted for when it left the factory.
