Idiomas disponibles
Idiomas disponibles
7 Working with the device
• Never work without dust protection mask and
safety glasses. Some dusts have a hazardous
effect! Materials containing asbestos may not
be machined!
• Do not work with damaged tools!
• Ensure the work piece is fi xed securely! Loo-
se work pieces should be clamped in a sui-
table fi xture. This prevents the work pieces
from fl ying about.
• A correct and uniform speed achieves a high
performance, not excessive contact pressu-
re! Excessive pressure is to be avoided: it
only stresses the device and can even dama-
ge the bits and cutters!
• Hold the device without covering the ventila-
tion slots. If it overheats, you absolutely must
shut off the device and allow it to cool down.
Workpiece cleaning:
Naturally enough, it is essential that a dirty
workpiece be cleaned thoroughly prior to poli-
shing! Use of sandpaper is helpful here. Approp-
riate sanding sheets with a touch fastener layer
are available in our range (www.proxxon.com).
Polishing:
Warning!
Please ensure that the polishing tool is in a per-
fect condition and not worn or damaged. Parts
can break off and fl y about if polishing tools are
worn or damaged. This could result in injuries.
Please note:
Never work without polishing agent! Please note
that the ingredients of different polishing agents
play a decisive part in achieving the polishing
effect, not the mechanical action of the polishing
tool!
Therefore, the choice of polishing agent, whe-
ther emulsion, wax or paste, is decisive if the
desired result is to be achieved. Please ensure
that the correct agent is selected for the material
to be polished and the respective working stage.
Following application of the polishing agent to
the surface to be polished, the polishing pro-
cess can be continued as required with the
polishing felt disc and polishing hood.
The complete procedure should, depending on
requirements, be repeated until the desired re-
sult is achieved. Finally, the workpiece should
be cleaned of residual polishing agent using the
microfi bre cloth.
8 Accessories for the WP/A angle
polisher
Naturally enough, all the items described above
(except metal polishing paste) are also availab-
le as accessories from Proxxon.
For more detailed information on accessories,
please request our device catalogue from the
address specifi ed on the last page in the war-
ranty information.
Please note in general:
Proxxon bits and cutters have been designed
to work with our machines, which makes them
optimal for their use.
We will not assume any liability whatsoever
for the safe and proper function of our devices
when using third-party bits and cutters!
Service note
Please note: The mains power input for the
charger may only be replaced by our Proxxon
Service Department or a qualifi ed specialist!
9 Care and maintenance
Caution!
Remove the battery from device before any
assembly, adjustment, maintenance measure
or repair!
The device is broadly maintenance-free. For a
long service life, you should clean your unit af-
ter every use with a soft cloth or brush.
- 21 -
