Idiomas disponibles
Idiomas disponibles
• Assign a name to the installation and press the "add" button.
• Configure the Wi-Fi on your device by entering your network SSID and password (when asked "Do you want to
configure WIFI on your device?" Press the "YES" button) and press the "Accept" button.
• "Installation is complete. The internet gateway has switched to WiFi mode". Press the "ok" button.
Adding VorticeNET Cloud system
Add new installation
Name
Serial number
next
To add an installation you need the
mobile application.
Please type your own installation name and enter
serial number shown below.
SERIAL NUMBER: 1006859209
Back
Next
15. Wait a few seconds until the appliance is connected to the WiFi network (WiFi
panel).
Note: If the LED corresponding to the WiFi icon on the remote control panel is not steady, press the on/off button
again for a few seconds (approx. 4s) to connect the system to the WiFi network (WiFi LED steady).
16. From the cloud screen (either from the browser or the "VorticeNET" app, select "Installation list" and open the system
by pressing "Open".
Note: If the connection is still offline you will need to refresh the browser page or refresh the "VorticeNET" app
screen (alternatively close the app and reopen it).
Installation name:
VORT HRI 200 PHANTOM B
17. Select "new installation component" to add devices to the installation list.
new installation component
Enter the password that has been generated below.
VORTICE MVHR PASSWORD: 407741
Serial number
Address:
1006859209
Add the first device. Click the button to add
devices to the list.
Adding VorticeNET Cloud system
Add new installation
You are about to add a new installation
Enter the password from the mobile
application
Password resets in: 57 sec.
State:
No alarms
Adding VorticeNET Cloud system
Installation has been added. To use the server you
need to switch the devide to WiFi mode.
WiFi Mode
Warning! Switching to WiFi mode will disconnect
you from the devide! You can skip this step if you
want to continue using the VORTICE MVHR app.
Switching the device to WiFi mode can be done at
any time by holding down the button located on the
touch panel for 5 seconds.
Finish
Back
LED steady on the remote control
Connection:
online
ENGLISH
Open
51
