a brand of Hugo Lahme GmbH
4.5. Kein Wasseraustritt:
Absperrorgane geschlossen. Gegenstand verstopft den Wasserauslauf.
4.6. Massageanlage Total-Jet setzt sich nicht in Betrieb oder blockiert:
Gegenstand blockiert außerhalb der Massageanlage Total-Jet oder in der Mechanik. Stromversorgung unterbrochen.
Zuleitung defekt. Bewegungsmotor funktioniert nicht. Piezotaster defekt.
4.7.
Piezotaster funktioniert nicht:
Zuleitung defekt. Stromversorgung unterbrochen. Elektrischer Anschluss getrennt.
Elektronische Motorsteuerplatine defekt. Piezotaster defekt (durchgebrannt)
4.8. Bewegungsmotor funktioniert nicht:
Motor defekt bzw. blockiert. Stromversorgung unterbrochen. Elektronische Motorsteuerplatine defekt.
Elektrische Kabel getrennt. Sicherungen haben ausgelöst. Zuleitung defekt.
Installation and operating instructions for FitStar®
massage system Total-Jet
1. LOCATION
It is recommended that you position the pump and the blower so that the connection between the pump/blower and the fittings
is as short as possible. When installing the pump, please ensure that the axis of the suction line runs horizontally. If a relocation
of the pump or blower location is necessary for construction reasons, we recommend that a distance of max. 5m is not exceeded.
In order to prevent unnecessary loss of pressure in the suction line, please ensure that the pipes are installed horizontally and
without kinks. For longer distances, the cross-section of the suction line must be increased accordingly. The location of the pump
and of the blower should be selected so that the ambient temperature of 40° C is not exceeded. The pump must be installed
below the water surface as it is not self-priming as standard. The blocking elements, pump and blower must be easily accessible
at all times. It is absolutely necessary to provide ventilation and a floor drain in the pump shaft.
2. INITIAL OPERATION
Only operate the pump when the pool is filled. Do not allow the pump to run dry under any circumstances.
a.
Open both ball valves, check for leaks and turn on the unit.
b.
Check pipe connections under operating conditions.
c.
It is important to ensure that no water enters the blower.
3. INSTRUCTIONS FOR WINTER CARE IN OUTDOOR AREAS
The pump must be emptied. Close both ball valves and open the drain screw on the pump housing. The switch must never be
operated without voltage when non-operational (exception: maintenance work) as condensation can form. Winter use of the
piezo switch: for safety reasons, the piezo switch must be deactivated in the control box, i.e. set to winter mode!
To protect the electronic and mechanical components, we recommend disassembling the functional unit of the Total-Jet massage
system in winter and when it will be out of operation for a longer period. Store this safely in a dry and clean room. Close the
opening of the recess with the cover.
4. TROUBLESHOOTING
Plant does not supply sufficient power:
4-1.
Pump rotating in wrong direction. Water level not high enough. Pump taking in air. Ball valve not completely open.
Suction line leaking. Pump blocked (leaves, etc.)
If no cause can be detected, please notify customer service.
4-2. Pump cannot be switched on:
For pneumatic controls: air pressure sensitivity of the adjusting screw on the pressure wave switch in the pneumatic con-
trol must be adjusted:
For piezo controls: check cable between piezo button and control as well as the connection assignment of the control
and the switch for summer/winter mode.
Stand 04/2023
Tighten screw to make control more sensitive
Loosen screw to make control less sensitive
20
Art.-Nr.: 578913
