Initial commissioning
During first commissioning, the following special procedures should be noted. The pipe or hose connections must be in place for
the system to work.
Total-Jet function
- Press the Piezo switch to activate and start the system.
- The pump and the blower are now switched on. The vertical movement of the massage jets starts now.
- The direction and speed of the massage jet movement are software programmed and cannot be changed or adjusted.
- If the Piezo switch is pressed again during the vertical movement of the massage jets, the movement stops and the massage
jets stay in that position. The massage effect is concentrated on exactly this spot. The pump and the blower
continue to function.
- Pressing the Piezo switch again switches the system off or ends the massage.
Total-Jet massage system safety:
- An integrated board monitors/checks if the situation is hazardous during the movements of the Total-Jet massage system.
ATTENTION:
- When the Total-Jet massage system is operated by various persons or in a commercial area, the operator is responsible for
meeting all of the relevant legal provisions and guidelines, and for correctly operating the installation.
The manufacturer denies all liability in the event of non-compliance.
- The Total-Jet massage system should not be operated at water temperatures below 10° C or above 38° C.
- In general, it is forbidden to obstruct the functions.
- The Total-Jet massage system has only been designed for the functions described in the manual. The manufacturer denies all
liability for damage that arises due to use for non-permitted functions.
- Removing the safety fittings within the Total-Jet massage system is forbidden.
- Adding objects to the Total-jet massage system is forbidden.
- The Total-Jet massage system should not be operated by children without supervision.
- Die Total-Jet massage system may not be operated outside of water.
- Die Total-Jet massage system may not be operated horizontally.
- Die Total-Jet massage system may not be assembled without the correct installation recess.
- Die Total-Jet massage system may not be assembled without the correct functional unit.
- Die Total-Jet massage system may not be operated without the panel as a safety cover.
- Die Total-Jet massage system may not be assembled on uneven surfaces.
- The Total-Jet massage system may not be assembled if the distance to the upper edge of the installation recess is more than
20 mm.
- Water capacity at the entrance of the recess should be 8 m
- Air capacity at the entrance of the recess should be 20 m
- Pressure drop Total-Jet massage system 7 mWs.
- Water connection and air connection on Total-Jet massage system are Ø 32. This pipe width should only be maintained at the
last metre.
- Pipe diameter from the machine room to the entrance to the recess must be calculated by the fitter.
- The pipe diameter depends on the complete pool system.
Stand 04/2023
3
/h.
/h.
3
11
a brand of Hugo Lahme GmbH
Art.-Nr.: 578913
