Idiomas disponibles
Idiomas disponibles
If the device is so badly damaged that electric cables or drive parts are exposed, disconnect the
mains plug immediately and contact your service outlet. Unauthorized repair work may result in
the user suffering major injuries or even death.
Only personnel trained in how to use the device may make crimp pipe joints using the ROMAX
Compact III AMPShare.
The machine may only be used with a press jaw inserted into it. The press jaw must be in per-
fect technical condition.
Only start the machine if it is in perfect working order.
Servicing and repair work may only be carried out by workshops authorized by ROTHEN-
BERGER.
Use only suitable press jaws and press fitting systems that have been approved by ROTHEN-
BERGER.
After you have inserted the press jaw check that the bolt is securely locked.
In the event of problems during the pressing process, press the EMERGENCY STOP button.
Check that the pipe joint is secure after you have completed the pressing process.
Imperfect pipe joints must be compressed again using a new fitting.
Follow the installation instructions supplied by the fitting and pipe manufacturers.
Assure by pressing leaky press fittings that no humidity respectively lotic water reaches into the
inside of the machine!
After finishing the work, check the installation with appropriate testing equipment and assure that
it is leakproof!
In case of damage and improper use of the battery, vapours may also be emitted. Ensure
the area is well-ventilated and seek medical attention should you experience any adverse ef-
fects. The vapours may irritate the respiratory system.
Do not open the battery. There is a risk of short-circuiting.
The battery can be damaged by pointed objects such as nails or screwdrivers or by force
applied externally. An internal short circuit may occur, causing the battery to burn, smoke, ex-
plode or overheat.
Only use the battery in the manufacturer's products. This is the only way in which you can
protect the battery against dangerous overload..
Protect the battery against heat, e.g. against continuous intense sunlight, fire,
dirt, water and moisture. There is a risk of explosion and short-circuiting!
Transporting li-ion battery packs: The contained lithium-ion batteries are subject to the Dan-
gerous Goods Legislation requirements. The user can transport the batteries by road without fur-
ther requirements. When being transported by third parties (e.g.: air transport or forwarding
agency), special requirements on packaging and labelling must be observed. For preparation of
the item being shipped, consulting an expert for hazardous material is required. Only send the
battery pack if the housing is intact and no fluid is leaking. Remove the battery pack from the
machine for sending. Prevent the contacts from short-circuiting (e.g. by protecting them with ad-
hesive tape).
Dispatch batteries only when the housing is undamaged. Tape or mask off open contacts and
pack up the battery in such a manner that it cannot move around in the packaging. Please also
observe possibly more detailed national regulations.
2
Technical Data
Battery voltage ................................................ 18 V
Rated power consumption .............................. 281 W
Motor speed. ................................................... 20400 min
Maximum piston force ..................................... max. 21 kN
Pressing time (according to nominal size) ...... ca. 3 s
-1
ENGLISH
15
