Idiomas disponibles
Idiomas disponibles
Battery charge indicator:
The green LEDs on the battery charge indicator indicate the state of charge of the battery. For
safety reasons, it is only possible to check the state of charge when the power tool is not in op-
eration.
Press the button for the battery charge indicator
so possible when the battery is removed.
If no LED lights up after pressing the button for the battery charge indicator, then the battery is
defective and must be replaced.
The state of charge of the battery is also displayed on the user interface Status indications.
RO BP 18V ProCORE AMPShare
LED
5× continuous green light
4× continuous green light
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
Recommendations for Optimal Handling of the Battery:
Protect the battery against moisture and water.
Only store the battery within a temperature range of −20 to 50 C. Do not leave the battery in
your car in the summer, for example.
Occasionally clean the ventilation slots on the battery using a soft brush that is clean and dry.
A significantly reduced operating time after charging indicates that the battery has deteriorated
and must be replaced.
Follow the instructions on correct disposal!
3.2
EMERGENCY STOP Button
If there is any danger to personnel or the machine during the pressing process, press the
EMERGENCY STOP button immediately and release the ON switch. The valve will open and
the piston will return to its initial position.
3.3
To switch on
Press the ON button until the pressing process has been completed. The motor cut out indicates
the end of the moulding cycle.
A short press on the ON button activates the Bluetooth function and allows you to connect to the
app.
3.4
To turn the press jaw
The press jaw can be turned through 270° depending on the application.
3.5
LED
White LED lights up for 5s after a short keystroke or completed pressing process.
Green LED lights up briefly after pressing the keystroke - pressing process can be performed.
Green LED lights up after pressing process- the pressing process is completed.
Red LED flashes when the battery is low.
Red LED lights up for 3s after pressing the key if the machine is not ready for operation.
Red LED lights up for 3s after not complete pressing process.
Yellow LED indicates necessary maintenance.
or
RO BP 18V AMPShare
Capacity
LED
80–100 %
3× continuous green light
60–80 %
2× continuous green light
40–60 %
1× continuous green light
20–40 %
1× flashing green light
5–20 %
0–5 %
ENGLISH
to show the state of charge. This is al-
Capacity
60–100 %
30–60 %
5–30 %
0–5 %
(B-1)
(B-2)
(B-3)
(C)
17
