Idiomas disponibles
Idiomas disponibles
3.6
To insert the press jaw
Remove battery!
Open the bolt (1).
Insert the appropriate press jaw for the job in hand (2).
Lock the bolt (3).
After changing the press jaw it is essential to ensure that, once engaged, the crimping jaw
matches the profile being moulded and the nominal width of the fitting being moulded. A visual
inspection must be carried out in order to determine that the press jaw is fully closed at the end
of the press cycle.
3.7
Operation
Use only system-compatible press fittings and press jaws designed for them. The nominal size
of the press jaw must be identical with the nominal size of the press fitting.
When inserting the pipe / press fitting system, there is a risk of crush injuries for the
fingers or other body parts near the press jaw!
Push the press fitting on to the pipe (1). Pull the press jaw apart and insert the pipe with the
press fitting at right angles.
There must be no foreign bodies between the press contour and the fitting. If you fail to
ensure this, the pressing process will not produce a perfect joint!
Press the ON button until the pressing process has been completed (2). The motor cut out
indicates the end of the moulding cycle.
Push the press jaw apart and take the machine off the joint (3).
Do not start the machine while the piston retracts or the emergency shutdown is pressed!
4
Care and Maintenance
Remove the battery prior to carrying out any work on the machine.
Check that the press jaws are fully functional. Damaged press jaws must not be used and must
be sent to an authorised ROTHENBERGER repair shop.
Check that the press jaw and drive rolls move freely.
Check the bolt for signs of damage at regular intervals. Have damaged bolts replaced by an au-
thorised ROTHENBERGER repair shop.
Clean and grease the drive rolls, the bolt and press jaws when you have finished work.
Use only high quality pressing or ball bearing grease.
The pressing contour must be kept free of grease.
All other servicing, maintenance and repair work must be carried out by an authorized
ROTHENBERGER repair shop.
If the seal is damaged the warranty will be null and void.
After 40.000 pressing cycles or 2 years have the machine serviced by an authorized ROTHEN-
BERGER workshop.
When dispatching the machine ensure that it is packed in its carrying case completely with bat-
tery and charger in the carry case only.
Electro-hydraulic machine does not exceed 3 hours in a -5° C / 23°F storage.
5
Accessories
You can find suitable accessories in the main catalog or at www.rothenberger.com
6
Customer service
The ROTHENBERGER service locations are available to help you (see listing in catalog or on-
line) and replacement parts and service are also available through these same service locations.
Order your accessories and spare parts from your specialist retailer or using RO SERVICE+
online: + 49 (0) 61 95/ 800 8200 sf + 49 (0) 61 95/ 800 7491 [email protected] -
www.rothenberger.com
18
ENGLISH
(D)
(E)
