Idiomas disponibles
Idiomas disponibles
Initial Settings
2
Press MULTI-CONTROL to display the
setting mode.
3
Turn MULTI-CONTROL to select the AM
tuning step.
Turning MULTI-CONTROL will switch the AM
tuning step between 9 kHz and 10 kHz. The se-
lected AM tuning step will appear in the dis-
play.
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
1
Use MULTI-CONTROL to select
WARNING TONE.
2
Press MULTI-CONTROL to turn warning
tone on.
# To turn warning tone off, press
MULTI-CONTROL again.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source on page 28.
1
Use MULTI-CONTROL to select AUX1/
AUX2.
2
Press MULTI-CONTROL to turn AUX1/
AUX2 on.
# To turn AUX off, press MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (REAR SP:FULL/PREOUT:REAR)
or subwoofer (REAR SP:SUB W/
PREOUT:SUB W) connection. If you switch the
rear output setting to REAR SP:SUB W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (REAR SP:FULL). When rear out-
put is connected to full range speakers (when
REAR SP:FULL is selected), you can connect
the RCA subwoofer output to a subwoofer. In
this case, you can select whether to use the
subwoofer controller's (low pass filter, phase)
built-in PREOUT:SUB W or the auxiliary
PREOUT:REAR.
1
Use MULTI-CONTROL to select
SW CONTROL.
2
Press MULTI-CONTROL to display the
setting mode.
# Press BACK to return to the previous display.
3
Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press MULTI-CONTROL repeatedly to switch
the segment in the following order:
REAR SP (rear speaker setting)—PREOUT
(RCA output setting)
4
Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
When REAR SP (rear speaker setting) is se-
lected.
REAR SP:SUB W (subwoofer)—REAR SP:FULL
(full-range speaker)
When PREOUT (RCA output setting) is se-
lected.
PREOUT:SUB W (subwoofer)—PREOUT:REAR
(full-range speaker)
# When no subwoofer is connected to the rear
output, select REAR SP:FULL.
Section
04
25
En
