Cybex Silver PALLAS B2 i-SIZE Guia Del Usuario página 12

REMOVAL FROM THE VEHICLE
EN
Perform the installation steps in the reverse order.
1. Remove the top tether belt (8).
2. Unlock the ISOFIX locking arms (5) on both sides by pushing the ISOFIX
release buttons (10) and pull them back.
3. Pull the car seat away from the ISOFIX anchorage points (6).
4. Remove the car seat. Then press the ISOFIX adjustment handle (4) and
push the ISOFIX locking arms (5) back until you feel a slight resistance.
Release the adjustment handle and push the ISOFIX locking arms (5) fully
back into the transport position.
ADJUSTING THE RECLINE POSITIONS
This car seat offers 3 sitting positions.
1. To put the car seat in the desired recline position, press the ISOFIX
adjustment handle (4) on the underside of the front area of the booster (2)
and pull the car seat forward.
2. To return the car seat from the recline position to the sitting position, press
the ISOFIX adjustment handle (4) again and guide the seat upwards with
light pressure against the booster (2).
The three indicator lines on the ISOFIX locking arms indicate the respective
��
position.
The car seat has to be adjusted to one of the sitting positions before the
��
child is seated.
ADJUSTING THE HEADREST
The adjustable headrest (11) can be adjusted by using the adjustment
handle (12) at the back of the headrest. Adjust the headrest so that max. 2
cm (approx. 2 finger's width) remain between the child's shoulder and the
headrest.
�� The height of the headrest can still be adjusted while the car seat is installed
in the vehicle.
8
CORRECT INSTALLATION MODE
76 cm – 105 cm,
max. 21 kg, > 15 m
Installation mode with impact shield
Installation
SECURING THE CHILD WITH IMPACT SHIELD: 76 CM – 105 CM
(MAX. 21 KG, > 15 M)
1. Loosen the belt of the impact shield (13) by pressing the release button
(14) on the belt adjuster (15).
2. Open the buckle of the impact shield (16) and lay the impact shield on
its side.
3. Now place your child in the car seat.
�� Make sure that the headrest is adjusted correctly.
4. Push the impact shield (3) back into the designated guide and insert the
tongue of the impact shield (17) into the buckle of the impact shield (16) so
that it engages with an audible "CLICK".
5. Now pull on the belt of the impact shield (13) to adjust it and restrain your
child correctly. Move the impact shield (3) a little bit by tilting it back and
forward to achieve an optimal fit and position.
6. Adjust the impact shield (3) so that it fits snugly against the child's body
and pelvis and is positioned centrally in front of your child.
�� The tightening of the belt must be repeated each time you buckle up.
7. Check whether the tongue of the impact shield (17) is properly engaged by
pulling on the impact shield (3).
100 cm – 150 cm
without impact shield