Parkside PRPA 20-Li B2 Traduccion Del Manual De Instrucciones Originale página 11

Getting started
Assembly
Mounting the wall bracket
♦ Remove the screw+nut z from the clamp in the
wall bracket t.
♦ Insert the nut z on the back of the wall
bracket t into the hexagonal recess (see fig. B).
♦ Attach the wall bracket t to the wall using
three screws (not included). Note, the distance
from wall bracket t to the rain barrel is restrict-
ed by the length of the connection cable 0
and the depth of the rain barrel.
Attaching the operating unit (fig. B)
♦ Hook the operating unit 8 into the wall bracket
t.
♦ Fasten the operating panel 8 onto the wall
bracket t using the screw z.
Connecting the connection hose
♦ Screw the quick-connect adapter o with the
sealing ring p onto the thread of the pump q.
♦ Push the connection hose u onto the quick-con-
nect adapter o.
Attachment to the rain barrel
Instead of using the wall bracket t, you can also
attach the operating unit 8 directly onto the rain
barrel.
♦ Hook the clip a instead of the wall bracket t
into the operating unit 8.
♦ Attach the clip a to the edge of the rain barrel.
│ GB │ IE
■ 6
Immersing the pump
WARNING!
■ Make sure you do not hold or hang the appli-
ance by the connection cable 0. Damage to
the connection cables may cause an electric
shock.
♦ Use the plastic hook i or the connection hose
u to immerse or raise the pump.
♦ Place the pump into the rain barrel. Note that
the maximum immersion depth is 1.8 m due to
the length of the connection hose u.
♦ Hook the plastic hook i onto the edge of the
rain barrel.
♦ Wind the excess connection cable 0 around
the pump and fix the cable onto the side of the
pump using one of the cable clips w.
NOTE
► Be careful that dirt and sand may accumulate
in the bottom of the barrel over time and this
could damage the pump.
We recommend placing the pump on a brick.
Shortening the connection hose (fig. C)
You can shorten the connection hose u to prevent
the excess length from causing problems.
♦ Press the connection hose u out of the plastic
hook i.
♦ Unscrew the union nut l from the connecting
piece k.
♦ Pull the connection hose u out of the connect-
ing piece k.
♦ Shorten the connection hose u to the desired
length by cutting off the excess.
♦ Re-attach the connection hose u to the con-
necting piece k and the plastic hook i in the
reverse order.
PRPA 20-Li B2