Idiomas disponibles
Idiomas disponibles
• Hold the device without covering the ventila-
tion slots. If it overheats, you absolutely must
shut off the device and allow it to cool down.
Firstly switch on the tool before using it to sand
down and satin-fi nish the work piece. Start with
a low rotational speed to check the effect on
the surface. Then keep increasing the rotational
speed until optimum work results are obtained.
Hold the tool in your right hand and guide it with
your left hand at the grip as shown in Fig. 3.
Good work results depend primarily on the cy-
linder being accurately aligned. The grip allows
the tool to be guided exactly parallel to the work
piece surface. There is a risk when not working
with the grip that tool tilting may produce grin-
ding marks and striations on the surface.
Guide the tool at an acute angle to the cham-
fer or rounded edges when working on them
(Fig. 4).
8 Accessories for the WAS/E cylin-
der sander
Caution!
Before cleaning, adjusting, service or repair,
disconnect the mains plug!
Naturally enough, all the Proxxon operational
tools described above are also available as
accessories.
For more detailed information on accessories,
please request our device catalogue from the
address specifi ed on the last page in the war-
ranty information.
Please note in general:
Proxxon bits and cutters have been designed
to work with our machines, which makes them
optimal for their use.
We will not assume any liability whatsoever
for the safe and proper function of our devices
when using third-party bits and cutters!
- 12 -
Service note
Please note: The mains power input may only
be replaced by our Proxxon Service Department
or a qualifi ed specialist!
9 Care and maintenance
The device is broadly maintenance-free. For a
long service life, you should clean your unit af-
ter every use with a soft cloth or brush.
The exterior of the housing can be cleaned
with a soft, possibly damp cloth. A mild soap
or other suitable cleaning agent may be used
during this. Solvents or cleaning agents con-
taining alcohol (e.g. petrol, cleaning alcohols
etc.) should be avoided, since these can attack
plastic casings. In any event, make absolutely
certain that no liquids penetrate into the interior
of the device.
10 Disposal
Please do not dispose of this machine in
household refuse! The device contains reusable
materials which can be recycled. If you have
any questions about this, please contact your
local disposal company or other appropriate
local facilities.
