Husqvarna CL400 Manual De Usuario página 11

dangerous gas. Do not start the engine indoors or
in closed spaces.
• Before you do the maintenance on the product, stop
the engine and remove the ignition cable from the
spark plug.
• Do the maintenance work correctly to increase the
lifetime of the product and decrease the risk of
accidents. Let an approved service agent do the
professional repairs. Speak to your nearest service
agent for more information.
• Only do the maintenance work written in this
operator's manual.
• Use heavy duty gloves when you touch the cable
laying equipment.
Introduction
WARNING:
product, carefully read and understand
the safety chapter and the assembly
instructions.
To install the drill
1. Put the drill (A) into the drill head (B) and install the
long screw (C). (Fig. 16)
Note:
A 6 mm hex key is necessary to install the
drill.
2. Install the drill head on the shaft (D) with the short
screw (E).
3. Tighten the screws.
To install the cable
The product has a clutched cable winder that can be
removed.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Water the ground the day before operation during
the summertime or if the soil is dry.
2. Make sure that people, animals are at least 20 m
away from the product.
3. Put the cable onto the cable winder. Refer to
install the cable on page 11 .
1394 - 003 - 05.12.2023
Assembly
Before you assemble the
Operation
Before you operate the
To
• Keep the product clean for the best and safest
performance.
• Let your service agent regularly examine the product
and make necessary adjustments and repairs.
• Replace damaged, worn or broken parts.
• Obey the instructions for how to change accessories.
Only use accessories from the manufacturer.
• When not in operation, keep the product in a dry,
indoor and locked area. Make sure that children and
persons that are not approved cannot get access to
the product.
1. Put the cable onto the cable winder. Use the knob to
turn the cable winder clockwise.
Note:
The cable must be installed clockwise on
the cable winder so it unwinds smoothly during
operation.(Fig. 17)
2. Push the cable into the tube in the feeding fin
(A) until the cable comes out from the bottom (B)
approximately 5 cm. (Fig. 18)
To install and remove the cable winder
1. Loosen the knob (A). (Fig. 19)
2. Remove the retainer (B).
3. Remove the cable winder (C).
4. Install the cable winder (D). Use the adapter if it is
necessary. (Fig. 20)
5. Install the retainer (E) and tighten the knob (F).
4. Adjust the cable laying depth. Refer to
cable laying depth on page 12 .
5. Attach the end of the cable to a stake.
To fill fuel
If available, use low-emission/alkylate gasoline. If low-
emission/alkylate gasoline is not available, use good
quality unleaded gasoline or leaded gasoline with octane
number not less than 90.
CAUTION:
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
To adjust the
Do not use gasoline with an
11