Change V-Belt; Track Saw Blade; Setting The Blade Guide; Upper Guide - HOLZMANN MASCHINEN HBS 700 Manual De Instrucciones

15.3.4 Change V-belt

 Remove the blade.
 Turn the belt tension hand wheel (V) to release tension from the
drive belt.
 Loosen and remove the drive wheel securing nut and washer
(A2) (located at the rear of the saw).
 Remove the drive belt and the pulley.
 Place the new drive belt over the pulley on the main drive
wheel.
 Re-fit the drive wheel to the saw and fully tighten the lock nut
to secure.

15.3.5 Track saw blade

 Loosen the lock star knob (O).
 With the top door open, turn the drive wheel by handle.
 Continue to turn the drive wheel and at the same time turn the
blade tracking lever (P).
 Turn both the drive wheel and the blade tracking knob until the
blade is sitting on the centre of the drive wheel.

15.3.6 Setting the blade guide

 The guides should be adjusted so that the blade is about 0.5
mm from the guide.

15.3.7 Upper guide

 Loosen the knurled jam nuts (Q).
 Rotate the adjusting rod (R) counterclockwise.
 Adjust the distance with the two Allen screws.
 (S) large movements; (T) small movements.
 Move the guide until the guide is set in the right position.
 Re-tighten all Allen screws to secure the guide in place.

15.3.8 Lower guide

 Loosen the knurled jam nut (Q) and the wheel (R).
 Adjust the distance with the two Allen screws.
 (U) large movements; (T) small movements.
 Move the guide until the guide is set in the right position.
 Re-tighten all Allen screws to secure the guide in place.
After setting and before switch on turn the upper wheel roll by hand a few times
to see if the band saw runs out of the rollers. If this is the case, the blade must
be aligned again.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
HOLZBANDSÄGE / MWOOD BAND SAW / SIERRA DE CINTA / SCIE À RUBAN
N O T I C E
MAINTENANCE
A
Seite 42
HBS 700 – HBS 800