Metabo S 18 LTX 115 Manual Original página 15

Slightly acidic, flammable fluid may leak
from defective Li-ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately
with plenty of water. If battery fluid leaks
out and comes into contact with your eyes, wash
them with clean water and seek medical attention
immediately.
Remove the battery pack from the machine before
any adjustments, conversions or servicing are
performed.
Before fitting the battery pack, make sure that the
machine is switched off.
5 Overview
See page 3.
1 Sliding on/off switch
2 Spindle locking button
3 Clamping screw for protective cover
4 Dust filter
5 Guide roller (for surface processing) *
6 Spindle
7 Protective cover with auxiliary handle
8 Electronic signal indicator
9 Battery pack release button
10 Capacity indicator button
11 Capacity and signal indicator
12 Battery pack
13 Tool fixing screw and hexagon spanner
14 Tensioning spindle
15 Key
16 Open-ended spanner
17 Distance sleeves (for tools shorter than
100 mm)
* equipment-specific
6 Special Product Features
Spindle lock
Spindle lock for simple tool change.
Guide roller (equipment-specific)
The guide roller allows for good guidance of the
machine and sensitive metering of the press-on
pressure.
7 Scope of delivery
The machine is also available with different acces-
sory parts. An overview can be found on page 4.
Subject to change.
A Battery pack
B Flap/nylon web grinding wheel
8 Initial Operation
Protective cover
The protective cover (7) can be turned as required.
Ensure the protective cover is firmly seated.
Tighten the clamping screw (3) with an Allen key if
necessary.
Tensioning spindle
Holding the spindle locking button down, (2)
screw the tensioning spindle (14) onto the spindle
(6) and tighten with an open-ended spanner (16).
Guide roller (equipment-specific)
If flat surfaces are being processed, it is advisable
to attach the guide roller (5) as shown on page 3.
8.1 Dust filter
See illustration A on page 3.
Always fit the dust filter if the surroundings
are heavily polluted (4).
The machine heats up faster when the dust
filter is fitted (4). It is protected by the elec-
tronics system from overheating (see chapter13).
To fit:
See fig. page 3. Attach the dust filter (4) as shown.
To remove:
Holding the dust filter at the edges, raise it slightly
(4) and then pull it downwards and remove.
8.2 Rotating battery pack
See illustration B on page 3.
The rear section of the machine can be rotated
270° in three stages, thus allowing the machine's
shape to be adapted to the working conditions.
Only operate the machine when it is in an engaged
position.
8.3 Battery pack
Charge the battery pack before use (12).
If performance diminishes, recharge the battery
pack.
The ideal storage temperature is between 10°C
and 30°C.
"Li-Power" li-ion battery packs have a capacity
and signal indicator: (11)
- Press the button (10), the LEDs indicate the
charge level.
- If one LED is flashing, the battery pack is almost
flat and must be recharged.
ENGLISH
ENG
15