Idiomas disponibles
Idiomas disponibles
The m_achin÷ beeps
and display
shows
error codes:
EO- Washer door was not shut properly during the delay start mode. Close the
washer door properly to continue_
E] - Draining is too slow. The hose could be blocked, cut or not properly sek
Adiust the hose properly in order to drain. Replace the new hose if it is cut.
E2 - The washer has stopped running during the Wash/Spin/Rinse
mode_ The
washer door is not closed properly_ Close the top washer door properly to
continue_
E3 - The washtub is not spinning. This is due to the washer not being levded
properly or an overloaded tub. Adiust the leveling legs to balance the washer.
Remove some clothing and rearrange the clothes inside the tub. The machine
will start within 10 seconds after being rebdanced.
E4 - incoming water flow is very slow. This is due to improper opening of the
faucet, a blocked water inlet valve, or low water pressure. Open the water
faucet properly to increase the incoming water flow and clean the inlet valve.
E5 - Incoming hot water temperature exceeds 122°F/50°C. Regulate incoming hot
water temperature as shown above. You must Jetthe hot water cool down.
Once the hot water has coded down, press the "Start/Pause" button to resume
the cycJe.
E6 - Water sensor is defective. The washer needs servicing. Call for service.
E8 - The power voltage is too Jaw. Unplug the unit and wait for the voltage to return
to normak
E9 - The power vdtage is too high. Unplug the unit and wait for the voltage to
return to normal.
ProbJems with water:
® Not enough water is coming out- The water faucet may need to be turned fully.
Water hoses may be tangled or benk Straighten the hoses. Check the water level
selection. It may need to be readjusted_
® Water leaks - Thisis
due
to
improper installationof the drain hoseor fiJJhoses.
Your homedrain may be clogged or it may have constantwater pressure.You
may need to tighten hoses,checkthe plumbing or caJJ a pJumben
Water does not drain - This is due to improper installationof the drain hose_ You
may need to connectthe drain hoseproperly'.Checkthe position of the drain
hose_
Water flows out of the drain hoseduring the first useof the machine - Thismay
be the water left in the tub after the factory inspectedthe unit to testits
performancein order to ensurethe bestquality.
24
